CFM Corporation 7000 owner manual Match Lighting, HOW to Shut OFF the Grill

Page 26

Lighting Instructions

MATCH LIGHTING

IMPORTANT! The match-lighting hole is found under the front right corner of the grill bottom. When match lighting the grill, use the gas-control knob on your RIGHT-HAND side (closest to the match-lighting hole).

Repeat steps 1 to 4 of “Lighting Instructions.”

STEP 5. To match light: push down and turn the RIGHT burner control knob counter-clock - wise to the high setting.

STEP 6.

IMMEDIATELY strike a long wooden match and position the burning match through match-light- ing hole in the grill bottom. Extend the flame near a burner port in the bottom edge of the burner. The burner should light.

To light the other side of the burner, press in and turn the opposite control knob. The flame will track around the burner. Allow grill to preheat with the grill lid closed for five minutes before cooking.

CAUTION: Do not touch any hot grill parts. The outside of the grill bottom becomes very hot during use. It may be necessary to use pro- tective gloves.

HOW TO SHUT OFF THE GRILL

STEP 1. Turn the burner-control knob(s) off. The burner flame will go out.

STEP 2. Turn off the top L.P. cylinder valve by turning the knob in a clockwise direction until it stops.

IMPORTANT: Always have the gas shut off at the L.P. cylinder valve when the grill is not in use. The L.P. cylinder has a leak detection fea- ture which will restrict the amount of gas flow to the burner if the tank shut-off valve has not been turned off prior to the next use.

Locating the Match Lighting Hole

The match lighting hole is located beneath the lower right corner of the grill-bottom casting.

26

Image 26
Contents Model Series Table of Contents Formerly NowSeries 7000 Models Choosing a Safe Location for a Gas Barbecue Grill Not for USE by ChildrenPortable L. P. Gas Barbecue Grills GasTransporting a Full Cylinder Take These Instructions to the L.P. Gas Dealer Example a Filling a Type 1 Cylinder ValveAssembly Instructions Chapter Identifying the Grill Parts Assembly Step Unpack grill partsAssembly Assemble the Pillar to Base Tools neededYour grill will now look like this Assembly Attach the Grill Bottom Use hardware bag BMake sure the control-valve ends are Assembly Assemble the Grill Lid Page Assembly Attach the Side Tables to the Grill Assembly Install the Rock Grate and Briquettes No tools are neededAssembly Install the Cooking Grids Installing an L.P. Gas Cylinder No tools neededConnecting an L.P. Gas Cylinder Connecting the Regulator to CylinderModel 7000N Connecting to Natural Gas Installation for Natural GASOperating the QUICK-CONNECT To Disconnect the Fuel SupplyUse and Care Directions Chapter Leak Testing How to Check the Fuel-Supply System for Gas LeaksIgniter Lighting System Lighting InstructionsHOW to Shut OFF the Grill Match LightingTo Break in a NEW Grill Using Your Gas GrillControl Settings BURNER’S FlameReplacement Parts for Series 7000 Grills Main Hardware BagBottom/Burner Assembly consisting Breakdown of Preassembled Components