CFM Corporation 7000 owner manual Your grill will now look like this

Page 11

2. Position the pillar upside down, and set the base onto the pillar as shown.

Working from the open side of pillar:

3. Insert four bolts through the holes in the pillar and through the four holes in the base. Thread nuts onto bolts. Align rear holes and insert bolts. Add nuts and use wrenches to tighten.

4. Carefully turn the assembly upright.

5. Check the preassembled control valve located inside the pillar. Remove the plastic film covering the front of the control panel plate.

Your grill will now look like this >

11

Image 11

Contents Model Series Formerly Now Table of ContentsSeries 7000 Models Not for USE by Children Choosing a Safe Location for a Gas Barbecue GrillGas Portable L. P. Gas Barbecue GrillsTransporting a Full Cylinder Example a Filling a Type 1 Cylinder Valve Take These Instructions to the L.P. Gas DealerAssembly Instructions Chapter Unpack grill parts Identifying the Grill Parts Assembly StepTools needed Assembly Assemble the Pillar to BaseYour grill will now look like this Use hardware bag B Assembly Attach the Grill BottomMake sure the control-valve ends are Assembly Assemble the Grill Lid Page Assembly Attach the Side Tables to the Grill No tools are needed Assembly Install the Rock Grate and BriquettesAssembly Install the Cooking Grids No tools needed Installing an L.P. Gas CylinderConnecting the Regulator to Cylinder Connecting an L.P. Gas CylinderInstallation for Natural GAS Model 7000N Connecting to Natural GasTo Disconnect the Fuel Supply Operating the QUICK-CONNECTUse and Care Directions Chapter How to Check the Fuel-Supply System for Gas Leaks Leak TestingLighting Instructions Igniter Lighting SystemMatch Lighting HOW to Shut OFF the GrillBURNER’S Flame Using Your Gas GrillControl Settings To Break in a NEW GrillMain Hardware Bag Replacement Parts for Series 7000 GrillsBreakdown of Preassembled Components Bottom/Burner Assembly consisting