Assembly Step 7 - Installing the Grill Head
Tools Needed:
Phillips head screwdriver
LOCATE THESE PARTS:
Grill Head
Assembly
USE HARDWARE ”F”
A M6x15mm | B M6 Flat | C Bolt |
|
Bolt (4) | Washer (4) | Gasket | (4) |
1.Holding the grill head upright, slightly rotate the knob side down and set it onto the frame assembly. The knobs will insert through the control panel first, then rotate the grill head down until it rests properly onto the frame.
2.Line up the 4 bolt holes near the inside corners of the grill tub. (The lid will need to be opened to access the bolt locations.)
3.Loosely insert all of the bolts with washers and gaskets.
4.After all bolts are threaded, make sure the control knobs centered and securely tighten the bolts.
C
B
A
16