CFM Corporation A053041 owner manual Assembly Install the Tank Retainer

Assembly Step 4 - Install the Tank Retainer

USE HARDWARE ”C”

Tools Needed:

Phillips head screwdriver

A M4 Wing	B M4x10mm	C M6 Wing
Nut (1)	Bolt (1)	Nut (6)

1. Insert the legs of the wire tank retainer

LOCATE THESE PARTS:

B

A

Wire

into the mounting brackets inside the grill

legs. The wire tank retainer must be

mounted on the wheel side of the grill.

2. Align the center hole of the x-brace wires,

insert the M4 bolt through both wires, and

thread on the M4 wing nut as

shown above right.

3. Insert the ends of the wire x-brace

into the mounting

holes located

near the

middle of the grill legs

and threadC a M6 wing

nut onto each end.

4. Thread M6 wing nuts onto the ends of the wire tank retainer.

X-Brace

Wire Tank

Retainer

C

13