CFM Corporation A053041 owner manual Match Lighting

Page 26

Lighting Instructions

MATCH LIGHTING

IMPORTANT: The match lighting hole is found under the front right corner of the grill bottom. When match lighting the grill, use the gas control knob on your RIGHT-HAND side (closest to the match lighting hole).

Repeat steps 1 to 4 of “Igniter Lighting Instructions.”

STEP 5. To match light: push down and turn the RIGHT burner control knob counterclockwise to the high setting.

STEP 6. IMMEDIATELY strike a match and position the burning match through match lighting hole in the grill bottom. Extend the flame near a burner port in the bottom edge of the burner. The burner should light. (A match holder is supplied in the hardware pack to hold and extend the match into the burning chamber.)

To light the other side of the burner, press in and turn the opposite control knob. The flame will track around the burner. Allow grill to preheat with the grill lid closed for five to ten minutes before cooking.

CAUTION: Do not touch any hot grill parts. The outside of the grill bottom becomes very hot during use. It may be necessary to use protective gloves.

HOW TO SHUT OFF THE GRILL

STEP 1. Turn the burner-control knob(s) off. The burner flame will go out.

STEP 2. Turn off the top L.P. cylinder valve by turning the knob in a clockwise direction until it stops.

IMPORTANT: Always have the gas shut off at the L.P. cylinder valve when the grill is not in use. The L.P. cylinder has a leak detection feature which will restrict the amount of gas flow to the burner if the

tank shut-off valve has not been turned off

prior to the next use.

Match Light

Access Hole

Locating the Match Lighting Hole

The match lighting access hole is located underneath the bottom of the grill tub.

28

Image 26
Contents Great Outdoors Table of Contents Formerly NowFrame Model Series Gas Grill Gas L.P. Fuel Supply SystemFuel Regulator and Hose Transporting a Full Cylinder Take These Instructions to the L.P. Gas Dealer Filling and Purging Type 1 L.P. GAS CylindersTools needed to assemble grill tools included Getting StartedUnpacking the Grill Parts Assembly Identifying the Grill Parts Locate these partsAssembly Attach Legs to X-Frames Assembly Attach the Feet Assembly Install the Tank Retainer Assembly Attach the Modesty Panel Assembly Attach the Side Tables Assembly Installing the Grill Head Assembly Ignitor Installation Installing the BatteryAssembly Installing the Lid Handle No tools are required for this stepAssembly Installing the Grids Assembly Install the Warming Rack Assembly Install the Drip Cup Assembly Attaching the L.P. Gas Cylinder Connecting the L.P. Gas Cylinder Connecting the Regulator to CylinderUse and Care Directions Chapter Leak Testing How to Check the Fuel Supply System for Gas LeaksLighting Instructions Igniter Lighting SystemMatch Lighting Model A053041 Replacement Parts USA Canada