Cleaning The Performance and Advantage Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting the grill.
1.Turn gas off at control knobs and LP tank.
2.Remove cooking grids and vaporizer tents.
3.Remove two pal nuts,
4.Under grill remove grease pan and tray. Clean with soap and water.
5.Disconnect battery and under console disengage ignitor wire.
6.Wipe ceramic electrode with rubbing alcohol and cloth.
7.Clean
8.If grill is to be stored, coat burners lightly with cooking oil. Wrap in protective cover to keep insects out. If not storing use following steps.
VERY IMPORTANT: Burner tubes must engage valve openings as shown (A).
9.Attach ignitor wire to electrode. Replace battery.
10.Reposition cooking grids and vaporizer tents. Place clean grease tray and pan into grill bottom.
11.Before cooking again on grill, perform a “Leak Test” and “Burner Flame Check”.
Do not use ceramic briquets or charcoal in your grill.
Cleaning the Performance and Advantage Grease Tray
Performance and Advantage Series grills are equipped with a removable grease tray. Although grease will drain from the grease tray to the grease cup provided, food particles and debris may accumulate in the bottom and should be removed after cooking 5 to 10 times. This can easily be done by sliding the grease tray out of the rear of the unit. Make sure in replacing the tray to push it all the way forward.
CAUTION |
•Handles close to the lid can become hot. Lift handle in the middle where it remains cool.
14