Cleaning The Rotisserie Burner
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting the grill.
1.Turn gas off at control knobs and LP tank.
2.Disconnect ignitor wire from electrode (A).
3.Remove thumbscrew from shield (B), remove shield and clean any accumulation of grease with soap and water.
4.Unfasten hinge pins and hitch pin. Note how hinge pins and hitch pins are attached.
5.Using a garden hose (preferably with nozzle), force water through burner tube. Make sure water comes out of every burner porthole. Open clogged portholes with a thin wire.
6.Examine rotisserie housing and burner closely (C). If any cracks or large holes (other than portholes) are found replace rotisserie burner.
7.Wipe ceramic portion of electrode (A) with rubbing alcohol and cloth.
8.If grill is to be stored, coat burners lightly with cooking oil. Wrap in protective cover to keep insects out. If not storing use following steps.
9.After burner has been cleaned, place rotisserie burner onto back of grill bottom and attach with hinge pins and hitch pins.
10.Place gas tube inside burner tube, put shield over burner tube and secure with thumbscrew.
VERY IMPORTANT: Burner tubes must engage gas tube as shown (D).
11. Attach flat end of ignitor wire (A) to electrode.
Thumbscrew
Shield | B | Hitch Pin |
Burner Tube
Hinge Pin
Rotisserie Burner
A
BACK OF GRILL
Gas Tube
Electrode
Hinge Pin
Housing | Hitch Pin |
Ignitor Wire
D
C
| Burner Tube | |
Burner Portholes | Gas Tube | |
Burner Tube | ||
|
16