Char-Broil 463821909 manual #10-24 X Machine Screw Qty.4 #10-24 Flange Nut

Page 18

A Place bottom of front panel into three slots in the bottom shelf.

B Attach front panel to legs with four #10-24x2" machine screws and #10-24 flange nuts.

#10-24 X 2”

Machine Screw

Qty.4

#10-24 Flange Nut

Qty.4

Place valve/hose/regulator onto control panel. Attach with #10-24 x ½” machine screws. NOTE: Make sure the two valve stems are centered in their clearance holes; otherwise, this can cause main burner level problems. Attach ignitor to control panel using the stamped nut that's provided. NOTE: if your grill come with Snap-in ignitor, please see Option.

Ignitor

#10-24 x ½”

Machine Screw

Qty.2

Option: Snap the

ignitor into the control

panel.

Stamped Nut

Valve/Hose/Regulator

Snap-in

Ignitor

Valve/Hose/Regulator

Image 18

Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLava Rock / Briquettes TemperatureFirst Time Use Pre-Heating Your GrillIndirect Cooking Food SafetyDirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Routine Care Why Clean?General Cleaning Storing Your GrillLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas UL listed Overfill ProtectionUseDo not household cleaning agents. Damage to gas Connecting Regulator To The LP TankFor your safety LP Tank ExchangeTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator Shelf fascia not Shown for clarityIgnitor Lighting Safety TipsFor Safe Use Of Your Grill And To Avoid Serious Injury SDo not lean over grill while lightingBurner Flame Check Sideburner Ignitor LightingSideburner Match Lighting Hose CheckCleaning the Burner Assembly Turn gas off at control knobs and LP cylinderCorrect burner-to-valve engagement Burner Tube Valve Limited Warranty Statement REV Disclaimer of Implied Warranties and Limitation of RemediesParts List DescriptionNot Pictured Parts Diagram Assembly Leg ExtenderCone side of wheel against leg Axle Bolt Qty.2 #10-24 X Machine Screw Qty.4 #10-24 Flange Nut Burner Assembly #10-24 x ½ Machine Screws Machine screws and silicon washers#10-24 Screw Qty #10-24x2Wing Screw #10-24x2 Valve Carriage Bolts #10-24 X#10-24 Wing Screw Qty Flange Nuts Qty8 #10-24 X ½ Qty4 Machine Screw Lower HingeCenter flat portion of hinge on bottom Page Pivot Wire Swing Away Leg Cooking Grate Heat TentTank Wire Troubleshooting Emergencies Possible Cause Prevention/SolutionElectronic Ignition