Char-Broil 463821909 manual Machine screws and silicon washers, #10-24

Page 19

5

Attach control panel to firebox using #10-24 x ½” machine screws, silicon washers and #10-24 flange nuts.

Firebox

#10-24 x ½”

Machine Screw

Qty. 4

Silicon Washer

Qty. 4

#10-24

Flange Nut

Qty. 4

Control Panel

6

A Place firebox onto cart, make sure the regulator hose hangs inside cart and control panel overlaps front panel.Attach to cart with #10-24x1-1/4" machine screws, Silicon washers and #10-24 flange nuts.

B Place burners assembly into firebox, making sure valves are inside the burner tubes. Attach to firebox with #10-24 x ½”

machine screws and silicon washers.

C Attach wire of main burner to ignitor.

Burner Assembly

	#10-24 x ½”		B
	Machine Screws	Silicon Washer	B
	Machine Screws	Silicon Washer	#10-24
	Qty. 2	Qty: 6	Flange Nuts
			Qty. 4
	#10-24x1-1/4"
	Machine Screw
	Qty: 4
		A
		Firebox

Correct burner-to-valve engagement

Front Panel

C

19

Image 19

Contents Date Purchased Estimated assembly time 30 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsPre-Heating Your Grill TemperatureFirst Time Use Lava Rock / BriquettesRotisserie Cooking Food SafetyDirect Cooking Indirect CookingUsda Recommended Safe Minimum Internal Temperatures Storing Your Grill Why Clean?General Cleaning Routine CareUL listed Overfill Protection USE and CareLP Liquefied Petroleum Gas LP Cylinder FillingLP Tank Exchange Connecting Regulator To The LP TankFor your safety UseDo not household cleaning agents. Damage to gasShelf fascia not Shown for clarity Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator Turn all grill control knobs to OFFSDo not lean over grill while lighting Safety TipsFor Safe Use Of Your Grill And To Avoid Serious Injury Ignitor LightingHose Check Sideburner Ignitor LightingSideburner Match Lighting Burner Flame CheckTurn gas off at control knobs and LP cylinder Cleaning the Burner AssemblyCorrect burner-to-valve engagement Burner Tube Valve Disclaimer of Implied Warranties and Limitation of Remedies Limited Warranty Statement REVDescription Parts ListNot Pictured Parts Diagram Leg Extender AssemblyCone side of wheel against leg Axle Bolt Qty.2 #10-24 X Machine Screw Qty.4 #10-24 Flange Nut Machine screws and silicon washers Burner Assembly #10-24 x ½ Machine Screws#10-24 #10-24x2 Valve Carriage Bolts #10-24 X Qty #10-24x2Wing Screw ScrewFlange Nuts Qty8 #10-24 X ½ Qty4 Machine Screw Lower Hinge #10-24 Wing Screw QtyCenter flat portion of hinge on bottom Page Cooking Grate Heat Tent Pivot Wire Swing Away LegTank Wire Emergencies Possible Cause Prevention/Solution TroubleshootingElectronic Ignition