Char-Broil 463821909 manual Tank Wire

Page 24

Insert tank wire into holes in bottom shelf of the cart.

Tank Wire

Hang grease cup clip from bottom of firebox and place grease cup into grease clip. Tank collar opening must face to left of grill. Set bottom of tank into bottom shelf. Rotate tank wire up to secure tank.

LP tank IS SOLD SEPARATELY. Fill and leak check the tank before attaching to grill and regulator (see Use & Care

Section). See Use & Care section of this manual to perform the "Burner Flame Check" and for important safety instructions

before using.

Grease Cup Clip

Grease Cup

CAUTION

Failure to install grease cup clip and cup will cause hot grease to drip from bottom of grill with risk of fire or property damage.

Always keep LP Tanks in

upright position during use,

transport, and storage

CAUTION

tank valve must face to front of cart once tank is attached. Failure to install tank correctly may allow gas hose to be damaged in operation, resulting in the risk of fire.

Image 24

Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionTemperature First Time UseLava Rock / Briquettes Pre-Heating Your GrillFood Safety Direct CookingIndirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Why Clean? General CleaningRoutine Care Storing Your GrillUSE and Care LP Liquefied Petroleum GasLP Cylinder Filling UL listed Overfill ProtectionConnecting Regulator To The LP Tank For your safetyUseDo not household cleaning agents. Damage to gas LP Tank ExchangeLeak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Shelf fascia not Shown for claritySafety Tips For Safe Use Of Your Grill And To Avoid Serious InjuryIgnitor Lighting SDo not lean over grill while lightingSideburner Ignitor Lighting Sideburner Match LightingBurner Flame Check Hose CheckCleaning the Burner Assembly Turn gas off at control knobs and LP cylinderCorrect burner-to-valve engagement Burner Tube Valve Limited Warranty Statement REV Disclaimer of Implied Warranties and Limitation of RemediesParts List DescriptionNot Pictured Parts Diagram Assembly Leg ExtenderCone side of wheel against leg Axle Bolt Qty.2 #10-24 X Machine Screw Qty.4 #10-24 Flange Nut Burner Assembly #10-24 x ½ Machine Screws Machine screws and silicon washers#10-24 Qty #10-24x2 Wing ScrewScrew #10-24x2 Valve Carriage Bolts #10-24 X#10-24 Wing Screw Qty Flange Nuts Qty8 #10-24 X ½ Qty4 Machine Screw Lower HingeCenter flat portion of hinge on bottom Page Pivot Wire Swing Away Leg Cooking Grate Heat TentTank Wire Troubleshooting Emergencies Possible Cause Prevention/SolutionElectronic Ignition