Char-Broil 463821909 manual

Page 22

Attach handle to front of lid with silicon washers , insulation washers and #10-24 wing nuts. Upper lid hinges attach to back with

#10-24x1/2" machine screws, fiber washers and #10-24 flange nuts. Do not tighten the screws.

Handle

#10-24 Wing Nut

Qty:2

#10-24X1/2”

Machine Screw Lid Qty:4

Silicon Washer

Qty:10

Upper Lid Hinge

#10-24 Insulation Washer

Flange NutsQty:2

Qty:4

Place lid assembly onto firebox, aligning hinges. Hinges on lid fit inside hinges on firebox. Secure with

hinge pins and hitch pins. Tighten upper lid hinges screws.

1” Hitch Pin

Qty. 2

Hinge Pin

Qty. 2

Image 22

Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLava Rock / Briquettes TemperatureFirst Time Use Pre-Heating Your GrillIndirect Cooking Food SafetyDirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Routine Care Why Clean?General Cleaning Storing Your GrillLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas UL listed Overfill ProtectionUseDo not household cleaning agents. Damage to gas Connecting Regulator To The LP TankFor your safety LP Tank ExchangeTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator Shelf fascia not Shown for clarityIgnitor Lighting Safety TipsFor Safe Use Of Your Grill And To Avoid Serious Injury SDo not lean over grill while lightingBurner Flame Check Sideburner Ignitor LightingSideburner Match Lighting Hose CheckTurn gas off at control knobs and LP cylinder Cleaning the Burner AssemblyCorrect burner-to-valve engagement Burner Tube Valve Limited Warranty Statement REV Disclaimer of Implied Warranties and Limitation of RemediesDescription Parts ListNot Pictured Parts Diagram Leg Extender AssemblyCone side of wheel against leg Axle Bolt Qty.2 #10-24 X Machine Screw Qty.4 #10-24 Flange Nut Machine screws and silicon washers Burner Assembly #10-24 x ½ Machine Screws#10-24 Screw Qty #10-24x2Wing Screw #10-24x2 Valve Carriage Bolts #10-24 XFlange Nuts Qty8 #10-24 X ½ Qty4 Machine Screw Lower Hinge #10-24 Wing Screw QtyCenter flat portion of hinge on bottom Page Pivot Wire Swing Away Leg Cooking Grate Heat TentTank Wire Troubleshooting Emergencies Possible Cause Prevention/SolutionElectronic Ignition