Char-Broil 463741510 manual Assembly, Left leg

Page 17

ASSEMBLY

1

Left leg

Place the leg shelf support with match holder onto leg as shown. Attach another leg support to other leg with no leg extender. Attach each side with #10-24x1-3/4" machine screw and #10-24 wing nut (A).

Attach one support bar to the upper part of legs with #10-24x1-3/4" machine screws and #10-24 wing nuts (B). NOTE: Do not tighten screws until Step 5.

Leg Shelf Support

Support Bar

 

A

#10-24x1-3/4’’ Machine Screw

#10-24

Wing Nut

#10-24x1-3/4’’

 

#10-24x1-3/4’’

Machine Screw

 

#10-24 Wing Nut

Machine Screw

Qty.6

 

 

Pay attention to the orientation of

#10-24

Left Leg during assembly

Wing Nut

Qty.6

B

2

Right leg

Place leg shelf support onto leg with leg extender. Attach each side with #10-24x1-3/4" machine screw and #10-24" wing nut. (A)

Attach one support bar to legs with #10-24x1-3/4" machine screws and #10-24 wing nuts.(B) NOTE: Do not tighten screws until Step 5.

Leg Shelf Support

Support Bar

A

#10-24x1-3/4’’

 

Machine Screw

#10-24

Wing Nut

#10-24x1-3/4’’

 

 

 

Machine Screw

 

#10-24x1-3/4’’

B

Qty.6

#10-24 Wing Nut

Machine Screw

 

 

 

#10-24

Pay attention to the orientation of

Wing Nut

Right Leg during assembly

Qty.6

 

17

Image 17
Contents Date Purchased Estimated assembly time 45 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsFirst Time Use TemperatureLava Rock / Briquettes Pre-Heating Your GrillDirect Cooking Food SafetyIndirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures General Cleaning Why Clean?Routine Care Storing Your GrillLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas LP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator For Safe Use Of Your Grill And To Avoid Serious Injury Safety TipsGeneral Grill Cleaning Turn controls and gas source or tank OFF when notIgnitor Lighting UseTurn gas OFF at control knobs and LP cylinder Cleaning the Burner AssemblyStoring Your Grill All Parts Year from date of purchase Limited WarrantyKey Qty. Description Parts ListKey Qty Description Not PicturedParts Diagram Left leg AssemblyRail #10-24 Wing Nut Qty.8 Cone side of wheel against legTank Exclusion Front PanelValve/Hose/Regulator and Ignitor Control PanelCorrectly assembled valve in burner tube and venturi clips Burner ,Firebox and Control KnobRight Side Sideburner Handle Lid Handle and Upper HingesVaporiser bar and Cooking Grate Swing Away Correctly Installed LP cylinder Emergencies Possible Cause Prevention/Solution TroubleshootingPiezo PUSH-BUTTON and Rotary Page