Ignitor Lighting
?Do not lean over grill while lighting.
1.Turn OFF gas burner control valves.
2.Turn ON gas at LP cylinder.
3.Open lid during lighting.
4.To ignite, turn left knob to the
5.Push IGNITOR button rapidly.
6.If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure.
7.To ignite right burner, turn knob to the
WARNING |
Turn controls and gas source or tank OFF when not |
in use. |
CAUTION
If burner does not light, turn knobs to OFF, wait 5 minutes, and try again. Always close valve during the 5 minute waiting period. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidentally ignite with risk of injury.
Match-Lighting
?Do not lean over grill while lighting.
1.Turn OFF gas burner control valves.
2.Turn ON gas at LP cylinder.
3.Open lid during lighting.
4.Place match into match holder (hanging from side of cart). Strike the match.
5.Place lit match through the match light hole and near the burner. Push in and turn left knob to the
Be sure the burner lights and stays lit.
6.Light right burner by pushing knob in and turning to the HI position.
NOTE: Your grill may NOT be equipped with a Sideburner!
Sideburner Ignitor Lighting
1.Turn OFF gas burner control valves.
2.Turn ON gas at LP cylinder.
3.To ignite SIDEBURNER, open sideburner cover.
4.Turn sideburner knob to the HI position. Push IGNITOR button rapidly.
5.If sideburner does not light in 5 seconds, turn knob to OFF, wait 5 minutes, then repeat lighting procedure.
Sideburner Match Lighting
1.Turn ON gas at LP cylinder.
2.Hold lit match to any port on the burner. Push in and turn sideburner knob to the HI position. Be sure burner lights and stays lit.
Burner Flame Check
•Remove cooking grates and flametamers. Light burner, rotate knobs from
a smaller flame in LOW position than seen on
LOW
Hose Check
•Before each use, check to see if hoses are cut, worn or kinked. Replace damaged hoses before using grill. Use only valve/hose/regulator specified in the Parts List.
Normal | Kinked |
Hose | Hose |
Turning Grill Off
•Turn all knobs to OFF position. Turn LP tank off by turning OPD hand wheel clockwise to a full stop.
Ignitor Check
•Turn gas off at LP tank. Press and hold ignitor button. "Click" should be heard and spark seen each time between collector box or burner and electrodes. See "Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is off at LP tank before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LOW position then turn back to OFF position. Valves should turn smoothly.
General Grill Cleaning
•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.
•Plastic parts: Wash with warm soapy water and wipe dry. ?Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.
•Porcelain surfaces: Because of
•Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy water. Wipe dry with a soft nonabrasive cloth.