Char-Broil 463263110 manual Wire, AA battery Cap

14

Inside of cart, connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the electronic ignition module. Total (5) connections. Connect the two wires {(a) and (b)} from the switch wiring harness into the back of the electronic ignition module. Total (2) connections, shown A.

Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart right side panel with the nut, shown B.

Insert AA battery into ignition module, negative (–) end first. Then put on the cap, shown C.

A

3	(a)	wire
4		1
5
	(b)	2

NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as A, B.

B

Electronic
ignition module	Right side panel

Heat shield Nut

C

- +

AA battery Cap

Under sideburner shelf, attach sideburner ignitor wire to electrode, shown A. Place sideburner grate onto sideburner shelf,
15 aligning grate legs with holes in shelf, shown B.
A
Electrode	B

Sideburner grate

Sideburner Ignitor Wire

23