Connecting Regulator to the LP Cylinder
1.LP cylinder must be properly secured onto grill. (Refer to assembly section of your grill manual).
2.Turn all control knobs to the OFF position.
3.Turn LP cylinder OFF by turning hand wheel clockwise to a
Full Stop.
4.Remove the protective cap from LP cylinder valve. Always use cap and strap supplied with valve.
| ck | wi |
lo | ||
ffC |
| se |
O |
|
|
OPD Hand Wheel
Type 1 outlet with thread on outside
Safety Relief Valve
Strap and Cap
Straight
Hold coupling nut and regulator as shown for proper connection to LP cylinder valve.
Connecting Regulator to the LP Cylinder (Con’t.)
6.Turn the coupling nut clockwise and tighten to a Full Stop. The regulator will seal on the
NOTE:
If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to complete the connection, do not use this regulator!
Do not use a POL transport plug (plastic part with external threads)! It will defeat the safety feature of the valve.
5.Hold regulator and insert nipple into LP cylinder valve.
Nipple has to be centered into the LP cylinder valve.
DANGER
Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.
WARNING
Outdoor gas appliance is not intended to be installed in or on a boat.
Outdoor gas appliance is not intended to be installed in or on an RV.
Never attempt to attach this grill to the
Do not use grill until
If a leak is detected at any time, STOP and call the fire department.
If you cannot stop a gas leak IMMEDIATELY close LP cylinder valve and call LP gas supplier or your fire department!
6