Grill Assembly
Assemble the Wheels
1.Place part of the shipping carton behind the grill for protection. Lay the grill on its back to assemble the four wheels (Fig. 8).
2.Assemble the locking wheels at the front of the grill. Secure each wheel with four metal washers and four screws. The washers assemble next to the heads of the screws.
3.Carefully lift the grill cart upright onto the wheels.
Fig. 8
Assemble the Wind Screen
1.Remove three screws and lockwashers at location “A”. These are the mounting screws for the rear windscreen (Fig. 9).
Fig. 9
A
2.Attach the rear windscreen with three screws. The lockwashers assemble next to the heads of the screws (Fig. 10).
Fig. 10
3.Assemble the side windbaffles. Each side windbaffle is held in place with four screws and lockwashers. The lockwashers assemble next to the heads of the screws (Fig. 11, 12, and 13).
Fig. 11 |
|
| Fig. 12 |
|
|
|
|
|
|
Fig. 13
Assemble the Grease Diverter
NOTE: On some models, the Grease Diverter is
1.The Grease Diverter is installed without tools. It is to be located right below the burners with tabs inserted into slots (Fig. 17).
2.Install the Grease Diverter from above by slipping it down between the burners and through the opening in the grill firebox (Fig. 14).
3.Once it is below all the burners, position it horizontally (Fig. 15) and align the tabs with the slots. A slight amount of spring tension in the diverter will hold it in place when the tabs are positioned in the slots (Fig. 16).
Fig. 14 |
|
| Fig. 15 |
|
| Fig. 16 |
|
|
|
|
|
|
|
|
|
Assemble the Heat Tents
and the Cooking Grates
Fig. 17 |
|
| Fig. 18 |
|
|
|
|
|
|
8