Coleman 9998 Series manual Hose and Regulator, Transporting the Refillable Cylinder

Page 5

Hose and Regulator

The Type 1 connection system has the following features:

1.The system will not allow gas to flow until a positive connection has been made.

NOTE: The cylinder control valve must be turned off before any connection is made or removed.

2.The system has a thermal element that will shut off the flow of gas in the event of a fire.

3.The system has a flow limiting device which, when activated, will limit the flow of gas to 10 cubic feet per hour.

4.NEVER use grill without leak testing this connection.

WARNING

DO NOT attempt to adjust the regulator as this could create a situation causing personal injury or property damage.

The pressure regulator and hose assembly with the Type 1 fitting supplied with the appliance must be used. Do not use another hose and regulator assembly other than the one supplied with the grill or a Coleman® replacement pressure regulator assembly. The pressure regulator and hose assembly provided is factory set at an outlet pressure of 11 inches water column (1/2 psi).

Keep the small vent hole in the regulator clean of dirt and debris (see item [G], Fig. 1).

Consult your L.P. gas dealer if you think the regulator is not working properly.

WARNING

During assembly of the grill and when attaching or replacing the L.P. gas cylinder, insure that the gas supply hose is free of kinks and/or damage and is at least 3 inches away from hot surfaces such as the grill housing.

Transporting the Refillable Cylinder

Transport only one refillable cylinder at a time.

Transport the cylinder in an upright and secure manner with a control valve turned off and the cap in place.

DO NOT transport the cylinder in the passenger compartment, unless you have an open window ventilation.

DO NOT leave the cylinder in direct sunlight or in a high heat area such as a closed car trunk. High heat areas could cause the relief valve to vent gas.

Use a cylinder cap on the cylinder valve outlet during transport and when the cylinder is not connected to the grill.

Keep the cylinder valve closed when not in use.

Take the cylinder directly home after it has been filled.

Transporting the Refillable Cylinder (continued)

WARNING

Handle a full cylinder with care. Gas is under high pressure.

DANGER

NEVER store a spare L.P. gas supply cylinder under the grill body or inside the grill enclosure or in the vicinity of any heat producing appliance. (Fig. 3)

NEVER fill the cylinder beyond 80% full.

Failure to follow this information exactly could result in an explosion and/or fire causing death or serious injury.

Fig. 3

REPRESENTATIVE ILLUSTRATION

5

Image 5
Contents Use, Care & Assembly Manual General Safety Information ContentsElectrical Attachments General InstallationGas Cylinder Cylinder SpecificationsPortable L.P. Gas Barbecue Cylinders Transporting the Refillable Cylinder Hose and RegulatorGrill Features 9998 Series Parts Identification 9998 Series Assemble the Wheels Grill AssemblyAssemble the Wind Screen Assemble the Grease DiverterAssemble the Thermometer Assemble the Grill LidAssemble the Propane Tank Retainer Assemble the Doors Handles Assemble the Doors and the Tool HookAssemble the Side Tables 20# LP Cylinder InstallationHow to Check for Leaks Leak Testing Refillable CylindersFixing a Fuel Leak When to test for leaksStart-Up Check List If you detect a leakMatch Lighting Lighting InstructionsLighting the Burners General Use and Correct Burner Flames Shutting Off the GrillCondition The Grill Burner FlameGrilling Tips and Hints Care, Maintenance and CleaningCase of Grease Fire Cooking MethodsSuggested Cleaning Materials Cleaning the VenturiComponent Cleaning Steps For Cleaning VenturiReinstall the burners, heat tents and the cooking grates Moving and Storage TroubleshootingSpecial Note Concerning L.P. GAS Cylinders For Your Additional SafetyColeman¨ Grill Warranty Registration Card Congratulations on Your NEW Coleman Grill Purchase Replacement Parts List 9998 Series Limited Three Year Warranty Warranty