Coleman 7700 Series, 7700 LP Gas Series manual Filling and Purging Type Gas Cylinders, CGA-510 POL

Page 6

Transporting the Cylinder cont.

WARNING

Handle a full cylinder with care. Gas is under high pressure.

DANGER

NEVER store a spare L.P. gas supply cylinder under the grill body or inside grill enclosure or in the vicinity of any heat producing appliance. (Fig. 12)

NEVER fill the cylinder beyond 80% full.

Failure to follow this information exactly could result in an explosion and/or fire causing death or serious injury.

12

Filling and Purging Type 1

L.P. Gas Cylinders

Take these instructions to the L.P. gas dealer.

DANGER

Purging and filling of L.P. Gas cylinders must be performed by personnel who have been thoroughly trained in accepted L.P. Gas industry procedures. Failure to follow this instruc- tion may result in explosion, fire, serious personal injury, or death.

When using cylinder exchange: If your grill is equipped with a Type 1 cylinder, be sure the exchanged cylinder is a Type 1 cylinder, as a 510 POL cylinder will not fit Type 1 regulator.

This tank is easily filled with a standard CGA 510 POL filling connection. (Fig. 13)

New cylinders must be purged before filling. Tell your L.P. Gas dealer if your cylinder is new and has not been previously filled. The L.P. Gas cylinder has a Type 1 cylinder valve with a back- check module in its outlet which will not permit gas to flow until an evacuation device is installed. To purge the L.P. Gas cylinder, the back-check module must be opened with an evacuation device.

6

Filling and Purging Type 1

L.P. Gas Cylinders cont.

13CGA-510 POL

Purging and Evacuating Devices for L.P. Gas Cylinders with Type 1 Cylinder Valves

CAUTION

After purging or filling an L.P. Gas cylinder, DO NOT insert a POL plug into the valve outlet. Insertion of the plug will pre- vent the back-check from closing. Use ONLY the provided cap and strap attached to the outlet. Close the cylinder valve knob before returning the cylinder to the customer.

For proper purging procedures refer to:

In the US: Safety Bulletin NPGA# 133, “Purging L.P. Gas Cylinders”, and Safety Bulletin NPGA #130, “Recommended Procedures for Filling Cylinders”.

A. Hose end valve with a bleed port (Fig. 13):

Purging can be accomplished using a hose end valve containing a bleed port which also allows for evacuation without the use of an adapter.

B. Hose end valve without a bleed port:

When a hose end valve does not have a bleed port, a separate device must be used for evacuation.

C. Purging using a Type 1 connection (Fig. 14):

L.P. Gas cylinder evacuation can be accomplished during each purging by using a Type 1 connection. The Type 1 valve outlet has an external 1 5/16" ACME right-hand thread which will accept this connection.

14

TYPE 1

Image 6
Contents Use, Care & Assembly Manual Contents General Safety InformationGeneral Installation Follow these safety rules before each useElectrical Attachments Fuel Connections Other Than Portable L.P. CylindersPortable L.P. Gas Barbecue Cylinders Hose and Regulator Cylinder SpecificationsGas Cylinder Transporting the CylinderFilling and Purging Type Gas Cylinders Take these instructions to the L.P. gas dealerCGA-510 POL Assembly/Set up Grill Label Hardware shown actual sizeRight Base Center BaseRight-Side-Up Support with one screwVP x2 each magnet Magnet Tighten all fastenersLocation Door Stop Hardware shown actual size HandleCart View of Grill from RearRear Center Panel 11-B 10-A11-A Rear Panel12-B Do Not Pinch Electrode Wires12-A Firebox Grill CartFirebox 13-A13-B 13-BFirebox Right Side Right Rear Panel 14-A 14-B14-C Flange15-C 15-A15-B 15-DALeft Fryer Assembly Left Rear Panel 16-B16-C 17-A 17-B 17-C17-D 18-B Fuel Hose from Fryer Assembly18-A 18-C19-A 19-BHooks Fryer Grease Pan 20-A 20-BFryer Heat Shield 21-A 21-B21-C 21-D 22-A Volt BatteryIgniter Button Wires Electrode Module23-A 23-B23-C 24-C 24-A24-B Without Tool With ToolWarming 25-A26-A Racks27-A 26-B26-C 27-B28-A 29-A29-B 31-A 30-A30-B 31-B31-C 32-A32-B 33-B 32-C33-A Handle Long Spit Rod Slip Collar Set Collar Forkx434-B 33-C34-A 34-C34-D35-A 35-B35-C Hose Connector Quick Disconnect Coupling Rubber Plug Quick Disconnect CouplingRubber Cap How to Check for Leaks Connecting Type 1 L.P. Gas CylindersLeak Testing Fixing a Fuel LeakStart-Up Check List Lighting InstructionsLighting Rotisserie Burner Lighting Main Burners Fryer Burner Lighting24b Shutting Off the GrillGeneral Use and Correct Burner Flames Grilling Tips and HintsCase of Grease Fire Cleaning the Venturi Cooking MethodsSide Fryer Cooking Methods Cleaning and Maintenance TroubleshootingMoving and Storage Problem Fire at any connection For Your Additional SafetyProblem Grill too hot Problem Flame behind control panel or control knob areaColeman¨ Grill Warranty Registration Card Congratulations on Your NEW Coleman Grill Purchase Page Page Page Warranty Coleman Gas Barbecue Grill Limited Warranty