Natural Gas Conversion Instructions
8.Install the NG valve assembly to the underside of the side burner with the two screws previously removed (Fig. 43).
Note: Make sure the NG valve is facing towards the front of the side burner and the valve stem is inserted into the hole.
9.Reattach the bezel to the front of the side burner and the NG valve with the two screws previously removed (Fig. 44).
Note: Make sure the bezel is installed in the correct position. The "H" will be facing the ignitor.
10.Reattach the control knob.
11.Connect the end of the new gas supply hose to the side burner valve assembly (Fig. 45).
12.Reattach the side burner igniter wire to the electrode.
This completes the side burner conversion.
Screw
Fig 43
Bezel
“H”
Fig 44
Fig 45
Underside of
side burner
12