Installing the NG regulator

1.Remove the hose from the brass flare fitting using an adjustable wrench. Located inside the cart on bottom of grill head (Fig. 20).

Remaining hose end still connected will be removed later.

2.Remove the brass flare fitting from the gas pipe (Fig. 21).

Note: For the following steps, the supplied pipe sealant needs to be applied to all pipe threads before the fittings are attached.

3.Remove the grommet in the side of the cart by pressing in on the side with your fingers (Fig. 22).

4.Attach the tee fitting to the gas pipe as shown. Make sure to apply pipe sealant before attaching fitting. Tighten with wrench (Fig. 23).

5.Attach the 3/8" MNPT to flared 90° elbow to the tee fitting as shown. Remember to apply pipe sealant to the pipe threads.

Tighten with wrench (Fig. 24).

Brass Flare

Fitting

Fig 20

Brass Flare

Fitting

Fig 21

Fig 22

Fig 23

Fig 24