Natural Gas Conversion Instructions
10.Disconnect the right side flexline from the mani- fold using the adjustable wrench. This will free up the right side of the manifold (Fig. 9).
11.Disconnect the left side flexline from the back infrared valve using an adjustable wrench. This will free up the left side of the manifold (Fig. 10).
12.Remove the control knobs from the front of the grill (Fig. 11).
13.Remove the two screws holding each bezel in place on the control panel (Fig. 12).
14.Remove the bezels from the front control panel. Note: The small bezel stays in place (Fig. 13).
15.Remove manifold from grill body (Fig. 14).
You are now ready to install
the new NG manifold.
Flex Line
Fig 9
Gas Inlet Flex Line
Manifold
Fig 10
Fig 11
Screws
Fig 12
Manifold
Fig 14
Fig 13
5