Natural Gas Conversion Instructions
6.Attach the 3/8" street elbow to the bottom of the bottom of the tee connector. Make sure to apply pipe sealant before attaching. Tighten with wrench (Fig. 25).
7.Reinsert the grommet in the side of the
cart (Fig. 22).
8.Attach one end of the supplied hose to the flared fitting on the side of the tee connector (Fig. 26 and 27).
9.Assemble the 3/8" pipe nipple to the NG regulator. Assemble the 3/8" FNPT to flared fitting to the regulator. Use pipe sealant and wrench tighten (Fig. 28).
10.Assemble the NG regulator with fittings to the 3/8" street elbow. The regulator should point toward the rear of the grill. Use pipe sealant and wrench tighten (Fig. 29).
Note: Pay attention to arrow on the NG regulator indicating direction of gas flow. The arrow should point toward the grill.
Remember to apply pipe sealant!
This completes the NG regulator installation.
Fig 25
Fig 26
Fig 27
Fig 28
Fig 29
8