Coleman 8200 Series, 8100 Series system manual This completes the Rear Infrared Burner Conversion

Page 9

Natural Gas Conversion Instructions

Converting the Rear Infrared Burner to NG

1.Remove the four screws on the inside of the grill that hold the rear infrared cover in place (Fig. 30).

2.Close the grill hood slowly.

3.Remove the two screws from the back infrared cover, located on the back of the grill (Fig. 31).

4.Grasp rear infrared cover and remove it from the grill.

5.Disconnect flex line and twist orifice elbow to remove LP orifice (Fig. 32 & 33).

6.Completely remove the LP orifice from the flared fitting and discard the LP orifice (Fig. 33).

7.Identification of the NG orifice (Fig. 34).

Note: NG orifice has a larger opening compared to the LP orifice being replaced.

8.Install the NG orifice into the flared fitting and tighten completely with an adjustable wrench (Fig. 33).

9.Reconnect the flexline (Fig. 32).

10.Replace the rear infrared cover. Install the two screws on the back infrared cover, located on the back of the grill (Fig. 31).

11.Open the grill hood slowly.

12.Reinstall the four screws on the inside of the grill that hold the rear infrared cover in place (Fig. 30).

This completes the Rear Infrared Burner Conversion.

Fig 30

Rear

Screws

Fig 31

Fig 32

Fig 33

Fig 34

9

Image 9
Contents Natural Gas Conversion Kit Natural Gas Conversion Instructions Tools Needed Screws Under lip You are now ready to install New NG manifold Natural Gas Conversion Instructions Installing the NG regulator Natural Gas Conversion Instructions This completes the Rear Infrared Burner Conversion Converting the Side Burner to NG Screws Igniter Wire Side Burner Valve Assy Casting This completes the side burner conversion Label the Grill Natural Gas Conversion Instructions Natural Gas Conversion Instructions 9992-448 6/21/06