Extron electronic setup guide Introduction, cont’d, System requirements, IPL T PC1 Introduction

Introduction, cont’d

Using GC2.3, you can configure a single room controller or create a web-based remote monitoring system for hundreds of A/V devices in multiple locations.

You may configure an IPL T PC1 interface using GC2.3 without having the device physically connected to the A/V network.

CUse Global Configurator version 2.3 or later. Update all PCs and devices running earlier versions of GC.

System requirements

The minimum system requirements for the PC on which you install Global Configurator include:

•Intel® Pentium® III 1 GHz processor

•Microsoft Windows® NT SP4, Windows 2000 SP2, or Windows XP SP2

•Microsoft Internet Explorer 6.0 with ActiveX enabled

NDepending on your computer settings, if ActiveX is not enabled, one of the following occurs:

•The system loads ActiveX automatically.

•The browser displays a prompt asking you if you want ActiveX to be loaded.

•The GlobalViewer control page does not open until you load ActiveX manually.

•Microsoft Windows Script 5.6

•512 MB of RAM

•50 MB of available hard disk space

•A network connection with a minimum data transfer rate of 10 Mbps; however, 100 Mbps is recommended.

Installing Global Configurator

Global Configurator software is available at no charge from

Extron.

Downloading and installing from the Extron Web site

To download and install Global Configurator on your PC:

1.	Visit the Extron Web site at www.extron.com.
2.	Click the Download tab.

3.	Click the IP Link® Software icon (shown
	at right).
4.	Click the Global Configurator icon
	(shown below).

5.	Click the Download Now button.
6.	Complete the personal information form.
7.	Click the Download GCSWxxxxx.exe button.
8.	Follow the remaining system prompts.

Installing from CD-ROM — Autorun enabled

To install Global Configurator from an Extron Software Products CD if Autorun is enabled on your PC:

1.	Insert the Extron Software Products CD into your drive.
2.	Wait for the Extron Software Products
	page to load.
3.	Click the Software icon (shown at right).
4.	Scroll down to the Global Configurator
	description, and click the Install link in the far right
	column.
5.	Follow the remaining system prompts.

Installing from CD-ROM — Autorun not enabled

To install Global Configurator from an Extron Software Products CD if Autorun is not enabled on your PC:

1.	Insert the Extron Software Products CD into your drive.
2.	From the Windows desktop, open My Computer and select
	the CD-ROMdrive.
3.	Double click launch.exe.
4.	Wait for the Extron Software Products page
	to load.
5.	Click the Software icon (shown at right).
6.	Scroll down to the Global Configurator
	description, and click the Install link in the far right
	column.
7.	Follow the remaining system prompts.

1-4 IPL T PC1 • Introduction IPL T PC1 • Introduction 1-5