Hardware Setup, cont’d
RS-232 port cabling
To connect an output device, such as a plasma display or projector, to the PC1's
Accessing the Communication Sheet
To obtain the Communication Sheet for your output device,
1. | On the Extron Web site (www.extron.com), click the |
| Download tab. |
2. | On the Download Center page, click |
| the Device Drivers button (shown at |
| right). |
3. | At the bottom of the Device Drivers |
| page, select IPL T PC1 from the pull- |
| down menu. |
4. | On the next page, select Serial from the Protocol Type |
| |
| drivers. |
5. | On the drivers list, locate the model name of your output |
| device. In the row for your device, click on the nnKb link |
| in the Communication Sheet column. |
In the example below, the Communication sheet link for a
6. | The Communication Sheet, a .pdf document, opens. You |
| can view, print, and/or download it. |
7. | Wire your display device as described in its |
| Communication Sheet. |
You can also access the Communication Sheets from the GC2.3 software by clicking the Comm Sheet button on the Serial Configuration tab. See "Assigning a serial driver" in chapter 3, "Software Setup," for more information.
Connecting to the display device
To connect the display device to the PC1,
1. Wire an
a. Connect the wire from the display's Receive port to the connector's first pin on the left, which plugs into the PC1's Tx (Transmit) port.
b. Connect the wire from the display's Transmit port to the connector's second pin, which plugs into the PC1's Rx (Receive) port.
c. Connect the ground wire from the display to the connector's third pin, which plugs into the PC1's ground () port.
IPL T PC1 | |
| Rear Panel |
Tx Rx +5V | |
|
Ground ( |
| ) |
| Ground ( |
| ) |
|
|
| ||||
| ||||||
Receive (Rx) | Receive (Rx) | |||||
Transmit (Tx) | Transmit (Tx) | |||||
|
|
|
|
|
|
|
BidirectionalDisplay
Device
d. Connect
2. Plug the cable into the
NThe
IPL T PC1 Interface • Hardware Setup | IPL T PC1 Interface • Hardware Setup |