Software Setup, cont’d
11.If desired, follow steps 5 through 10 to add more conditions. You can select either a port name or the device name and IP address in the Subject Port field. In the example below, a "day of the month" condition has been added.
NWhen you add multiple conditions, all of the conditions must be met in order for the specified
12. When finished adding conditions, click Next.
13. If desired, select an action and click Apply Action. If not, proceed to step 14.
14. Click Next again if you want to add an
15. If desired, select an
16. When finished, click Done. The dialog box closes.
Building and Uploading a GC File
Before a Global Configuration (GC) file is active in the GlobalViewer interface, the GC file must be “built” and “uploaded” to a GlobalViewer host device.
The “build” process compiles all of the configuration data you have entered into the GC file for each A/V network device.
The “upload” process delivers the built (compiled) file to the GlobalViewer host device.
After the GC file has been uploaded to a host device, you can launch the GlobalViewer interface by entering the host device’s IP address in the address field of an Internet browser.
Step Twelve: Build the Global Configurator file.
There are two Build commands:
Build All Configurations — Compiles configuration data for all devices in the GC file, including data for devices previously uploaded to a GlobalViewer host device.
Build Changed Configurations — Compiles configuration data only for devices that have been added or changed since the previous build cycle.
To initiate a “Build (all)” process,
1. From the Build menu, select Build All Configurations...,
or click the Build All Configurations icon (shown at right).
The Please Wait. Building Configuration(s)... dialog box opens and displays a progress bar while the GC file is being built.
| IPL T PC1 Interface • Software Setup |
