Ignitor Battery Installation - See Fig. 10
1.Unscrew the Ignitor Cap located on the grill Control Panel and remove the Contact and
Spring from the Ignitor Slot.
2.Place the manufacturer supplied AA battery
into the Ignitor Slot. Be sure to place the positive pole facing toward you. See Fig. 10.
Place the Spring over the AA battery, then place the Contact on top of the Spring.
Screw the Ignitor Cap back onto the grill Control Panel.
Remove all protective film from outside and
inside of Grill Head. IMPORTANT: Before
use of this grill please refer to Cleaning Exterior Stainless Steel Surfaces found on
page 18 of this Owner's Manual.
Figure 10
IGNITOR SLOT
IGNITOR CAP
\
AABATTERY
CONTACT SPRING
Electrode Check - Requires an Assistant
Before placing the cooking components into your grill, ensure that the Spark Electrode Tip is properly positioned within each Gas Collector Box (a
between each set of Burners.) The easiest way to ensure this is to perform this Electrode Check:
1.Be sure alt Control Knobs are set to "OFF" and open the Grill Lid.
2.Have an assistant stand behind to the right of the grill and look down at each Gas Collector Box. NEVER put your face inside Grill Head.
Press the Ignitor Cap. You should hear a "clicking" sound and your assistant should see a small blue spark within each Gas Collector Box. If a spark is present the Electrode Tips are properly positioned.
4.If no spark is seen the Spark Gap shown in Fig. 11 needs to be adjusted as follows:
Using an adjustable wrench, loosen the Inside Nut just until the Gas Collector Box can be maneuvered
and turned upward.
The gap between the Spark Electrode Tip and Spark receiver should be approximately 3/16".
If the gap is wider than 3/16" use a pair of long nose pliers and gently squeeze the Gas Collector Box
until the gap is correct.
Return the Gas Collector Box to its original horizon- tal position, secure the Inside Nut and try the Electrode Check again.
If no "clicking" sound is heard check the
following common causes. If you need assis- tance call our Customer Service Helpline at
•IgnitorAAbattery not installed properly.
•Ignitor wires may be loose. Remove the AA battery, inspect the Ignitor Junction Box found behind the Control Panel, and connect any loose wires.
Figure 11 - Side View
GAS COLLECTOR BOX
SPARK RECEIVER
13