Question:
can I convert my gas grill from one fuel type
to another, such as LP to NG (natural gas) or vice versa?
Answer:
No, your gas grill is manufactured to specific standards developed by CSA and ANSI for your safety and is certified for one type of gas only.
Question:
Are the serial and model numbers of my grill
listed somewhere for reference?
Answer:
The serial and model numbers are listed on a silver CSA label placed on the grill. Depending on the grill model, the silver CSA label generally will be located inside the right door of the cart.
Question:
My grill will not light properly. Why?
Answer:
Check these possibilities:
1.The gas supply is turned off at the LP tank. Turn on the gas at the LP tank.
2.Your LP tank is out of propane.
3.The regulator is not properly seated in the tank valve. Remove and reattach. Hand tighten only.
4.Crimped fuel supply hose. Inspect and straighten.
5.Regulator failure or damaged hose assembly.
Inspect and order a replacement part. Do not use your grill if you find a damaged hose assembly.
6.Gas not getting to the burners. Inspect the burners under the control panel to be sure they are aligned with the valve orifices.
7.Blockage in the gas system. Inspect burners and valve orifices for blockages, such as spider webs, insects, etc. Clean as necessary.
Question:
My electronic ignition is not working.
Answer:
Listen to hear the electronic igniter clicking. If not, check these possibilities:
1.Replace the AA battery. Ensure the "+" end is facing up and out.
2.Ensure the battery is centered and fits into
the electronic igniter button properly.
3.Be sure the wires are all attached to the electronic ignition assembly behind the control panel and the individual electrodes.
4.Inspect the electrodes to be sure they are not coated with grease or dirt. If so, clean with rubbing alcohol.
If you hear a clicking sound, then:
1.Inspect the electrodes to be sure they are not coated with grease and dirt. Clean with rubbing alcohol.
2.Inspect the distance from the electrode to the burner. It should be 1/8 to 1/4 inch from the
main burner and 1/8 to 3/16 inch from the side burner.
Question:
Sometimes I hear a humming sound coming
from my regulator. What causes this?
Answer:
The humming sound is gas flowing through the regulator. This is more likely to occur in periods of high gas flow. A low volume of sound is normal and will not interfere with the operation of your grill.
Question:
My grill has a low flame on some burners,
or some burners will not light at all. What can cause this?
Answer
This can be caused by the flow limiting device, which is generally triggered by a sudden change
in pressure. Opening the tank valve too fast or shutting the burners off using the tank valve can cause this. To reset:
1.Close the LP tank valve and disconnect the regulator assembly from the tank.
2.Let the LP tank sit for 10 minutes.
3.Open all burner control knobs, including the side burner, to "Hi" at the same time.
4.Close all burner control knobs.
5.Reconnect the gas regulator to the LP tank.
6.Follow the burner lighting procedures
and light the burner farthest from the LP tank.
28