Kenmore 119.1623 manual Hanuallylighting the Burners with Hatch Holder

Page 26

HANUALLYLIGHTING THE BURNERS WITH

THE HATCH HOLDER

I. Open the lid.

2.Ensure all burners are in the "OFF" position.

3.Slowly turn on the gas at the LP cylinder valve if it is not already on.

4.Place a match in the match light stick. This is located in the inside of a cabinet door.

5.Use the stick to slide the lit match through the cooking grates and the front of the heat diffuser to the burner you wish to light.

6, Press and turn the burner control knob to

"HI/LIGHT". Continue to push in and hold up to 5 seconds or until the burner lights.

Ifthe burner does not light within 5 seconds, turn the burner control knob to

"OFF". Wait 5 minutes for gas to clear, and try again.

8.When lit, turn the control knob to the desired heat setting

3.Slowly turn on the gas if it is not already

on.

4.Place a match in the match holder if

lighting the back burner. This is attached to the inside of a cabinet door.

5, Strike the match, and place near the top

of the burner if lighting the side burner or near the center of the back burner if

lighting the back burner.

6.Push in and turn the appropriate burner

control knob to "HI/LIGHT" and hold in.

7, Ifthe burner does not light within 5 seconds, turn the burner control knob to "OFF". Wait 5 minutes for the gas to clear, and try again.

8, For the back burner, continue to push and hold the burner control knob in for 5

to 7 seconds after the burner lights until the flame sensor begin operating.

Letting up on the burner control knob

before a high enough temperature has

been reached may cause the flame sensor to shut off fuel to the back

burner.

9.When lit, turn the burner control knob to its desired setting.

HANUALLY LIGHTING THE SIDE BURNER

OR THE BACK BURNER

i. Open the lid or side burner cover

2.Ensure the side burner and back burner control knob is in the "OFF" position as well as any main burner not in use.

1.Do not use charcoal briquettes, lava rock, or any type of ceramic product in this grill.

2.Do not put a barbecue cover or other flammable material in the storage area of this grill.

Never lean over the grill cooking area while lighting your gas grill. Keep your face and body a safe distance (at least 18 inches) from the lighting hole and burners when lighting your grill with a match.

26

Image 26
Contents Record Your SERIAL# Date of Purchase Attach Your Sales Receipt HereWarranty Restrictions One-Year Full Warranty on Kenmore GrillTen-Year Limited Warranty on Stainless Steel Burners Sears, Roebuck and Co Hoffman Estates, ILFailuretocomplywiththeseinstructionscould SB0029 QTY Purpose of PartItem No QtyDescription Qty Item No DescriptionItem No Description Qty Page KEY QTYQTY Ill Install Condiment Basket and Cabinet Door Stopper Assemble Side Burner Assembly Grease Pan SupportInstall Side Burner Control Panel to Side Burner Assembly Install Side Burner Assembly to Firebox AssemblySecure Side Burner Assembly to the Firebox Assembly Assemble Side Shelf Assembly \\\\IIIIAssembly Side Shelf Control PanelSecure Side Shelf Assembly to the Firebox Assembly Cabinet Place LP Cylinder into the CabinetHose Support Ring to Cabinet Side Panel Battery Congratulations Assembly in now CompleteCorrect LP GAS Tank USE Use your grill at least 2 feet away fromTo Connect the Cylinder to Regulator and Hose How to Leak Test your LP Gas Tank For your safetyRegulator Hand Tighten Only, Do Not Use a WrenchTransportation and Storage Disconnecting a Liquid Propane Gas LPG Tank From Your GrillFlow Limiting Valves on LP Gas Tanks Check all connections for LP Gas LeaksOT1 Hanuallylighting the Burners with Hatch Holder Hanually Lighting the Side Burner Or the Back BurnerTroubleshooting If the grill fails to light Follow the steps below to reset the flow limiting deviceCleaning the Grease Tray and Pan Cleaning The Cooking GratesCleaning the Heat Diffusers Cleaning Exterior SurfacesBurner Flames Using the Back Burner Cooking TemperatureAn Important Note About Cooking Temperature Burn-OffQuestion My grill will not light properly, Why? Answer Questions My electronic ignition is not working AnswerRepair Protection Agreements MY-HOMEIiiiiiiiiiiiiiii¸¸¸,¥o,.rHome