Kenmore 119.1643301 manual Toe Plate, Install Cabinet Doors and Cabinet Front Crossbar

Page 9

Install Cabinet

Toe

Plate

 

 

 

[]

Attach

the

Cabinet Toe

Plate to

the

Cabinet Bottom Panel using 4 Phillips Head Bolts

 

(M6xl0mm),

 

 

 

 

 

[]

Place

cabinet in

upright

position

on

casters,

Phillips Head Bolt M6xl0mm

Qty: 4

Install Cabinet Doors and Cabinet Front Crossbar

[] Insert the Cabinet Right Door bottom pin into the Cabinet Bottom Panel (Inset 1), and insert the Cabinet Right Door top pin into the Cabinet Front Crossbar (Inset 2), With door magnets extending into Cabinet, attach the Cabinet Front Crossbar to the right side of the Cabinet using

2 Phillips Head Bolts (M6x35mm) and Plastic Washers (M6) (Inset 3), Do not fully tighten bolts at this time,

[] Insert the Cabinet Left Door in the same way and attach Cabinet Front Crossbar to the left side

of the Cabinet using 2 Phillips Head Bolts (M6x35mm) and Plastic Washers (M6), Fully tighten all 4 Front Crossbar bolts at this time,

Phillips Head Bolts M6x35mm

Qty: 4

\

Plastic Washer M6

Qty: 4

Inset 2

9

Inset 1

Inset 3

Image 9
Contents Use & Care Guide Sears, Roebuck and Co,, Hoffman Estates, IL 60179 Kenmore Full WarrantyModel Number Serial Number Date PurchasedPRE-ASSEMBLY Page Key Qty Description Key Qty Page Remove Firebox from Cabinet Install Casters to CabinetToe Plate Install Cabinet Doors and Cabinet Front CrossbarAttach Firebox to Cabinet Hang Condiment Basket and attach Cabinet Door StopTray Grease Pan BracketCabinet IlInstall Towel Bar Handle, S Hooks Install Side Shelf Upper and Lower Front PanelsZnstall Towel Bar Handle Znstall Side Burner Upper and Lower Control PanelsInstall Side Shelf Frame to Firebox Install Side Burner Frame to Firebox Wire Install Side Burner ValveAttach Side Control Knob Side BurnerDiffusers Cooking Grates, Warming Rack InstallAssembly Now Install BatteryUse your grill at least 3 feet away from any Correct LP GAS Tank USERegulator and LP Cylinder Connections RegulatorHand Tighten Only, Do Not Use a Wrench Disconnecting a Liquid Propane Gas LPG Tank From Your Grill Flow Limiting Valves on LP Gas TanksCheck all connections for LP Gas Leaks Side Burner and Rotisserie Burner Grill Lighting InstructionsOFF. Wait Minutes for Gas to Troubleshooting If the grill fails to light Follow the steps below to reset the flow Limiting deviceControl knobs Cleaning the Heat Diffusers Cleaning The Cooking GratesCleaning the Grease Tray and Pan Cleaning the Inside of the Grill LidToreducethechanceof Flashback Ftre you must An Important Note About Cooking Temperature Cooking TemperatureUsing the Back Burner If Equipped Burn-OffQuestion My electronic ignition is not working Question My grill will not light properly. Why?Use your grill at least 3 feet away from any wall or surface MY-HOME Sears Installation ServiceWww,managemyhome,com Na9 ÷