Storage & Maintenance

TURNING OFF THE GAS FIREPIT:

1.Turn off the cylinder valve.

2.Turn burner control knob to the "OFF" position.

Note: Turn off LP cylinder first to prevent gas from being left in the system under pressure.

CAUTION:

• The cylinder valve should always be in the off, or closed, position when the firepit is not in use.

To turn off the cylinder valve, turn knob clockwise until it stops.

Note:	Observe flame height when lit: Flame
	should be a Blue/Yellow color and
	appear as illustrated. To clean lava rock,
	use a soft brush after the burner and
	lava rock have cooled completely. Never
	use a vacuum cleaner on the lava rocks.
	It is recommended that the firepit be
	stored indoors during the winter months
	if it will be subjected to freezing
	temperatures. The cylinder must be
	disconnected and removed from the
	firepit before the appliance can be
	stored indoors.

To obtain the best performance from your firepit, you must perform the following storage and maintenance activities on a regular basis:

•Allow at least 35 minutes for the firepit to cool down after use, then disconnect and remove the cylinder.

•Cylinder must be stored outdoors in a well-ventilated area out of the reach of children. Disconnected cylinders must have threaded valve plugs tightly installed and must not be stored in a building, garage or any other close area.

•Storage indoor is permissible only if the cylinder is disconnected and removed.

•Keep the firepit area clear and free from combustible materials, gasoline and other flammable vapors and liquids.

•If the firepit is not in use, it must be covered to protect from weather or other adverse elements.

•When firepit is stored for long periods of time, place lava rocks in storage bag provided.

•Installation and repair should be done by a qualified service person. The firepit must be inspected at least annually by a qualified service person.

•It is imperative that the control compartment, burner and circulating air passageways of the firepit be kept clean.