Weber SILVERC GENESIS Gas Grill, 55054 0100 manual Assemble wheel frame, Assemble frame

Page 11

Assembly Instructions

Assemble wheel frame

You will need: axle rod, two wheel hubcaps, two wheels, wheel frame, hammer and a block of wood. Place one end of the axle rod on the block of wood (or other protected surface). Tap one hubcap onto the end of the axle rod. Slide one wheel onto the axle, WEBER name facing out. Next, slide the other end of the axle rod through the wheel frame. Add the other wheel, WEBER name side facing out. Tap the hubcap onto the axle rod to complete the axle.

EB	R	W
EB		W
W			E
		R	B

Assemble frame

You will need: left frame, right frame, two 1/2 inch bolts, two nylon washers and a 7/16 inch or adjustable wrench.

Note - Work on carpeted area (on grass or one of the boxes) to protect the finish during frame assembly. Lay the leg frame pieces as shown so the leg tabs point up.

1)Connect the two frame pieces with the tabs inside of the frame.

2)Slip washers on bolts, then insert bolts as shown and tighten. (If you try to insert a bolt and there is no hole, you have the left frame turned the wrong way. Turn the left frame around.)

(1)

(2)

B069.a

B-1

Image 11

Contents Gas Grill Liquid Propane GAS Units only Customer Service Center South Hicks Road Palatine, IL WarrantyContents General Instructions Genesis Silver-C NG Page Page Page Page Assemble frame Assemble wheel frameAdd back panel Continue frame assemblyComplete frame assembly Add front panelInsert casters Add cooking box assemblyOmmend That this Installation be Done by a Professional Install Gas Supply General Specifications for PipingTest Connections Install igniterGas Line Piping Connect flexible hose to manifold Install manifold bracketCheck that all burner valves are off Install the slide out bottom tray Install Lid Right swing-up work surface Install the right end trim piece with tool holdersBoard Do not use the swing-up work surface as a cuttingYou will need side burner Install side burnerWay and do not add bolts yet Install the left end trim piece and swing-up workSurface Shown, do not push the trim piece in allDo not use the work surface as a cutting board Install the work surfaceChecking Check for gas leaksTime you disconnect and reconnect a gas fitting Your barbecue was dealer or store assembledBox with the rounded sides up Install Flavorizer Bars and Cooking GratesRetighten the fitting with a wrench and recheck for Set the cooking grates onto the ledges in the cookingInstall the thermometer Installing the warming rack Install the bottom shelfTo Extinguish LightingManual Lighting Lighting only the side burner Lighting the Side BurnerStorage CleaningCooking Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceWeber Spider Stopper Guards General MaintenanceReplacing Main Burners Crossover Ignition System Operations Smell of gas Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction withConjunction with the smell of gas Side Burner does not lightFlame is low in High position Flame is very yellow