Weber 55054 0100, SILVERC GENESIS Gas Grill manual Manual Lighting

Page 28

Manual Lighting

DANGER

Failure to open lid while igniting the barbecue’s burners, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

1)Open the lid.

2)Make sure all burner control knobs are turned OFF. (Push each burner control knob down and turn clockwise to ensure they are in the off position.)

3)Turn the gas supply valve on.

4)Strike a match and put the flame into the matchlight hole in the front of the cooking box.

1

2

7

3

4,6 5

*The grill illustrated may have slight differences than the model purchased.

WARNING: Do not lean over the open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

5)Push Front burner control knob down and turn to START/HI.

6)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box. You should see a flame.

WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

7)After the FRONT burner is lit you can turn on the other burner or burners.

Note - Always light the FRONT burner first. The other burner or burners ignite from the FRONT burner.

To Extinguish

Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply OFF at the source.

D-2

Image 28
Contents Gas Grill Liquid Propane GAS Units only Warranty Customer Service Center South Hicks Road Palatine, ILContents General Instructions Genesis Silver-C NG Page Page Page Page Assemble wheel frame Assemble frameContinue frame assembly Complete frame assemblyAdd front panel Add back panelAdd cooking box assembly Insert castersInstall Gas Supply General Specifications for Piping Ommend That this Installation be Done by a ProfessionalGas Line Piping Install igniterTest Connections Check that all burner valves are off Install manifold bracketConnect flexible hose to manifold Install the slide out bottom tray Install Lid Install the right end trim piece with tool holders Right swing-up work surfaceDo not use the swing-up work surface as a cutting BoardInstall side burner You will need side burnerInstall the left end trim piece and swing-up work SurfaceShown, do not push the trim piece in all Way and do not add bolts yetInstall the work surface Do not use the work surface as a cutting boardCheck for gas leaks Time you disconnect and reconnect a gas fittingYour barbecue was dealer or store assembled CheckingInstall Flavorizer Bars and Cooking Grates Retighten the fitting with a wrench and recheck forSet the cooking grates onto the ledges in the cooking Box with the rounded sides upInstalling the warming rack Install the bottom shelf Install the thermometerLighting To ExtinguishManual Lighting Lighting the Side Burner Lighting only the side burnerCooking CleaningStorage Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Weber Spider Stopper GuardsReplacing Main Burners Crossover Ignition System Operations Flame is low when burner is on Burners burn with a yellow orOrange flame, in conjunction with Smell of gasSide Burner does not light Flame is low in High positionFlame is very yellow Conjunction with the smell of gas