Weber 55054 0100, SILVERC GENESIS Gas Grill manual Install Lid

Page 18

Install Lid

You will need: lid, two hair pin cotters(1) and two hinge pins(2).

Place lid on top of the cooking box. Align the hinges at the rear of the barbecue. Insert hinge pins through the hinges from the outside. Insert hair pin cotters into the small holes in the hinge pins.

(1)

(2)

Install control panel and burner control knobs You will need: control panel, two Phillips screws/ washers, a Phillips screwdriver, and burner control knobs.

1)Set the control panel in place over both frame braces. Hold the Crossover Ignition button up while setting the control panel in place.

2)Line up the holes in the control panel with the holes in the white plastic plugs in the frame brace. Insert screws and tighten with a Phillips screw- driver until snug. Do not overtighten.

3)Push each of the burner control knobs onto their

valve.

(1)

(2)

(3)

B-8

Image 18

Contents Gas Grill Liquid Propane GAS Units only Warranty Customer Service Center South Hicks Road Palatine, ILContents General Instructions Genesis Silver-C NG Page Page Page Page Assemble wheel frame Assemble frameAdd front panel Continue frame assemblyComplete frame assembly Add back panelAdd cooking box assembly Insert castersInstall Gas Supply General Specifications for Piping Ommend That this Installation be Done by a ProfessionalInstall igniter Gas Line PipingTest Connections Install manifold bracket Check that all burner valves are offConnect flexible hose to manifold Install the slide out bottom tray Install Lid Install the right end trim piece with tool holders Right swing-up work surfaceDo not use the swing-up work surface as a cutting BoardInstall side burner You will need side burnerShown, do not push the trim piece in all Install the left end trim piece and swing-up workSurface Way and do not add bolts yetInstall the work surface Do not use the work surface as a cutting boardYour barbecue was dealer or store assembled Check for gas leaksTime you disconnect and reconnect a gas fitting CheckingSet the cooking grates onto the ledges in the cooking Install Flavorizer Bars and Cooking GratesRetighten the fitting with a wrench and recheck for Box with the rounded sides upInstalling the warming rack Install the bottom shelf Install the thermometerLighting To ExtinguishManual Lighting Lighting the Side Burner Lighting only the side burnerCleaning CookingStorage Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Weber Spider Stopper GuardsReplacing Main Burners Crossover Ignition System Operations Orange flame, in conjunction with Flame is low when burner is onBurners burn with a yellow or Smell of gasFlame is very yellow Side Burner does not lightFlame is low in High position Conjunction with the smell of gas