Weber 55054 0100 Side Burner does not light, Flame is low in High position, Flame is very yellow

Page 36

Side Burner Troubleshooting

WARNING: Before attempting any troubleshooting steps, all gas controls and supply valves should be in the OFF position.

Problem	Check	Cure
Side Burner does not light.	Is gas supply off?	Turn supply on.

Flame is low in HIGH position.	Is the fuel hose bent or kinked?	Straighten hose.

Flame is very yellow in	Inspect the Weber Spider Stopper	Clean Weber Spider Stopper Guard.
conjunction with the smell of gas,	Guard for possible obstructions.	(See section “Annual Maintenance”)
	(lockage of holes.)
OR
Burner makes popping noise in
conjunction with the smell of gas.

Push button ignition does not	Does burner light with a match?	If match lights burner, checkigniter
work.		(see below).

Side Burner maintenance

WARNING: All gas controls and supply valves should be in the OFF position.

Check igniter:

Make sure wire is connected between igniter and electrode. Check that igniter lock nut is tight.

Note: If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. Adjust igniter electrode to burner. Gap should be 1/8 to 3/16 inch from tip of electrode to burner. Spark should be a white/blue color, not yellow.

1)Igniter

2)Igniter Wire

3)Venturi/Burner

(1)				(2)
(1)

4)1/8 to 3/16 inch gap between electrode and burner

(4)

(3)

D-10

Image 36

Contents Gas Grill Liquid Propane GAS Units only Warranty Customer Service Center South Hicks Road Palatine, ILContents General Instructions Genesis Silver-C NG Page Page Page Page Assemble wheel frame Assemble frameContinue frame assembly Complete frame assemblyAdd front panel Add back panelAdd cooking box assembly Insert castersInstall Gas Supply General Specifications for Piping Ommend That this Installation be Done by a ProfessionalInstall igniter Gas Line PipingTest Connections Install manifold bracket Check that all burner valves are offConnect flexible hose to manifold Install the slide out bottom tray Install Lid Install the right end trim piece with tool holders Right swing-up work surfaceDo not use the swing-up work surface as a cutting BoardInstall side burner You will need side burnerInstall the left end trim piece and swing-up work SurfaceShown, do not push the trim piece in all Way and do not add bolts yetInstall the work surface Do not use the work surface as a cutting boardCheck for gas leaks Time you disconnect and reconnect a gas fittingYour barbecue was dealer or store assembled CheckingInstall Flavorizer Bars and Cooking Grates Retighten the fitting with a wrench and recheck forSet the cooking grates onto the ledges in the cooking Box with the rounded sides upInstalling the warming rack Install the bottom shelf Install the thermometerLighting To ExtinguishManual Lighting Lighting the Side Burner Lighting only the side burnerCleaning CookingStorage Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Weber Spider Stopper GuardsReplacing Main Burners Crossover Ignition System Operations Flame is low when burner is on Burners burn with a yellow orOrange flame, in conjunction with Smell of gasSide Burner does not light Flame is low in High positionFlame is very yellow Conjunction with the smell of gas