Weber SILVERC GENESIS Gas Grill manual Lighting the Side Burner, Lighting only the side burner

Page 29

Lighting the Side Burner

The side burner has a separate ignition system from the main cooking box.

DANGER

Failure to open the lid while igniting the side burner, or not waiting 5 minutes to allow the gas to clear if the side burner does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

Lighting only the side burner.

1)Open the side burner lid.

2)Check that the fuel gauge reads more than “E”.

3)Check that the side burner valve is turned OFF. (Push each knob down and turn clockwise to ensure they are in the off position.), and all main burner control valves are OFF (push down and turn clockwise).

4)Turn the LP tank valve on (turn clockwise).

5)Push down and turn the side burner control valve to HI.

6)Push the side burner igniter button several times so it clicks each time.

1

5

3

6

CAUTION: Side burner flame may be difficult to see on a bright sunny day.

WARNING: If the side burner does not light:

1)Turn OFF the side burner control valve.

2)Wait 5 minutes to let the gas clear before you try again or try to light with a match.

Lighting the side burner if the main burners are lit.

1)Open the side burner lid.

2)Push down and turn the side burner control to HI.

3)Press the side burner igniter button several times so it clicks each time.

1

2

3

CAUTION: Side burner flame may be difficult to see on a bright sunny day.

WARNING: If the side burner does not light:

1)Turn OFF the side burner control valve.

2)Wait 5 minutes to let the gas clear before you try again or try to light with a match.

D-3

Image 29

Contents Gas Grill Liquid Propane GAS Units only Customer Service Center South Hicks Road Palatine, IL WarrantyContents General Instructions Genesis Silver-C NG Page Page Page Page Assemble frame Assemble wheel frameComplete frame assembly Continue frame assemblyAdd front panel Add back panelInsert casters Add cooking box assemblyOmmend That this Installation be Done by a Professional Install Gas Supply General Specifications for PipingTest Connections Install igniterGas Line Piping Connect flexible hose to manifold Install manifold bracketCheck that all burner valves are off Install the slide out bottom tray Install Lid Right swing-up work surface Install the right end trim piece with tool holdersBoard Do not use the swing-up work surface as a cuttingYou will need side burner Install side burnerSurface Install the left end trim piece and swing-up workShown, do not push the trim piece in all Way and do not add bolts yetDo not use the work surface as a cutting board Install the work surfaceTime you disconnect and reconnect a gas fitting Check for gas leaksYour barbecue was dealer or store assembled CheckingRetighten the fitting with a wrench and recheck for Install Flavorizer Bars and Cooking GratesSet the cooking grates onto the ledges in the cooking Box with the rounded sides upInstall the thermometer Installing the warming rack Install the bottom shelfTo Extinguish LightingManual Lighting Lighting only the side burner Lighting the Side BurnerStorage CleaningCooking Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceWeber Spider Stopper Guards General MaintenanceReplacing Main Burners Crossover Ignition System Operations Burners burn with a yellow or Flame is low when burner is onOrange flame, in conjunction with Smell of gasFlame is low in High position Side Burner does not lightFlame is very yellow Conjunction with the smell of gas