Weber 55054 0100 Check for gas leaks, Time you disconnect and reconnect a gas fitting, Checking

Check for gas leaks	To perform leak checks: Slide back the collar of the
	quick disconnect. Push the male fitting of the hose into
m DANGER
	the quick disconnect, and maintain pressure (1). Slide
Do not use an open flame to check for gas
	the collar closed (2). If it does not engage or lock,
leaks. Be sure there are no sparks or open	repeat procedure. Gas will not flow unless the quick
flames in the area while you check for	disconnect is properly engaged.
leaks. Sparks or open flames will result in
		(1)
a fire or explosion, which can cause
serious bodily injury or death and damage
to property.		(2)
m WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
Note - All factory-made connections have been
thoroughly checked for gas leaks. The burners have
been flame-tested. As a safety precaution however, you
should recheck all fittings for leaks before using your
Weber Gas Barbecue. Shipping and handling may	Turn on gas supply.
loosen or damage a gas fitting.
	Check for leaks by wetting the connections with the
m WARNING: Perform these leak checks even if
	soap and water solution and watching for bubbles. If
your barbecue was dealer or store assembled.
	bubbles form or if a bubble grows, there is a leak.
You will need: a soap and water solution, and a rag or
	Note – Since some leak test solutions, including soap
brush to apply it.
	and water, may be slightly corrosive, all connections
Note - Since some leak test solutions, including soap
	should be rinsed with water after checking for leaks.
and water, may be slightly corrosive, all connections
	m WARNING: Do not ignite burners when leak
should be rinsed with water after checking for leaks.
	checking.
Make sure side burner is OFF.

C-6