Weber 625 manual Install Condiment Holders and Work Surfaces, Check for GAS Leaks

Page 10

INSTALL CONDIMENT HOLDERS AND WORK SURFACES

You will need: two condiment holders and two stainless steel work surfaces.

Place the condiment holders on the ends of the frame. Set the work surfaces on top of the condiment holders and the barbecue frame. Figure 18.

CHECK FOR GAS LEAKS

WARNING

The gas connections of your Weber Gas Barbecue have been factory tested. We do however recommend that you leak check all gas connections before operating your Weber Gas Barbecue.

Remove burner control knobs, control panel and front panel

Remove the burner control knobs. The control panel is separate from the front panel. The control panel needs to be removed before the front panel can be removed. Figure 19.

Control panel

Figure 18

Front panel

Figure 19

Put your fingers under the front edge of the control panel, lift up, and pull evenly toward you. Figure 20 (a).

Front edge of the control panel

(a)

Front Panel

Control Panel

Figure 20

10

Image 10
Contents Summit 425 Summit 450 Install GAS Supply Cart Installations only General Specifications for PipingTools Needed Remove Packaged ContentsSupplies Needed Remove Packaged Contents ADD Cooking ModuleMount Regulator Bracket ADD Right PanelInstall Flavorizer Bars Connect Flexible Hose to RegulatorInstall STEAM-N-CHIPS Smoker ADD Cooking GratesInstall Burner Control Knobs Install WARM-UP BasketInstall Bottom Tray Install Bottom Shelves Install Condiment Holders and Work Surfaces Check for GAS LeaksCheck for GAS Leaks Manifold Reinstall Front Panel Reinstall Control Panel Reinstall Burner Control KnobsInstall Tool Holders Refer to Operating Guide Before Lighting Barbecue