Weber 625 manual Remove Packaged Contents, ADD Cooking Module

Page 4

REMOVE PACKAGED CONTENTS (CONTINUED)

Catch pan holder

Catch pan

Drip pan

Stainless steel bottom shelves (For Summit 425 and 625)

Wire bottom rack

(For Summit 450 and 650)

Stainless steel work surface (2)

Condiment holder (2)

ADD COOKING MODULE

Caution: Use two people to lift and install the cooking module.

Lift the cooking module out of the packaging. The gas line, regulator, and bracket will hang below the module.

Lower the module on an angle into the cart so the control panel is under the front top frame rail. Figure 2. Guide the gas line regulator and bracket while lowering the module into the cart.

Flange

View from

right

Figure 2

Lower the back of the cooking module down so it is between the two flanges in the back panel. Figure 3. Use caution not to scratch the paint of the cooking module when setting the module between the flanges.

The cooking module should be level, setting on the front and rear top frame rails.

Flange

Tool holder (4)

Front top frame rail

Rear top frame rail

Hose

View from

right

Figure 3

4

Image 4
Contents Summit 425 Summit 450 Install GAS Supply Cart Installations only General Specifications for PipingTools Needed Remove Packaged ContentsSupplies Needed Remove Packaged Contents ADD Cooking ModuleMount Regulator Bracket ADD Right PanelInstall Flavorizer Bars Connect Flexible Hose to RegulatorInstall STEAM-N-CHIPS Smoker ADD Cooking GratesInstall Burner Control Knobs Install WARM-UP BasketInstall Bottom Tray Install Bottom Shelves Install Condiment Holders and Work Surfaces Check for GAS LeaksCheck for GAS Leaks Manifold Reinstall Front Panel Reinstall Control Panel Reinstall Burner Control KnobsInstall Tool Holders Refer to Operating Guide Before Lighting Barbecue