26 | OPERATING INSTRUCTIONS |
|
|
3)Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwise to ensure that it is in the OFF position.)
WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane cylinder tank valve. If they are not in the OFF position, when you turn on the LP cylinder valve, the "excess gas flow control" feature will activate, limiting the flow of gas from the LP cylinder. If this should occur, turn OFF the LP cylinder valve and burner control knobs. Then start over.
DANGER:
When the "excess gas flow control" feature is activated, a small amount of gas is still flowing to the burners. After turning OFF the cylinder and burner control knobs, wait at least 5 minutes for the gas to clear before attempting to light the grill. Failure to do so may result in an explosive
4)Turn the cylinder on by turning the cylinder valve counterclockwise.
WARNING: Do not lean over the open grill.
5)Push rotisserie burner control knob down and turn to START/HI. Continue to hold the control knob down. Continue to the next lighting step.
6)Push and hold down the Igniter button until burner ignites. You will hear the igniter sparking.
7)Continue to hold the control knob down until twenty (20) seconds after the burner has ignited.
8)Check that the burner is lit by looking for the rotisserie burner to glow red.
WARNING: If the rotisserie burner does not light, turn the burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.
Note- when using the rotisserie with the lid closed, only light two of the main burners on each side of the food(see Grilling
1 
8
3
6 | 4 |
|
3
5 ,7
*The grill illustrated may have slight differences than the model purchased.
SUMMIT® D
TO EXTINGUISH
Push down and turn the rotisserie burner control knob clockwise to OFF position. Turn gas supply OFF at the source.