| MAIN AND SMOKER TROUBLESHOOTING | 29 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| PROBLEM | CHECK | CURE |
|
|
|
|
|
|
| |
| Burners burn with a yellow or orange | Inspect Spider / Insect Screens for | Clean Spider / Insect Screens. (See Section | ||
| flame, in conjunction with the smell of | possible obstructions. (Blockage of | “Annual Maintenance”) |
|
|
| gas. | holes.) |
|
|
|
|
|
|
|
| |
| Burners do not light. | The excess fl ow safety device, which | To reset the excess fl ow safety device turn | ||
| a small flickering flame in the HIGH | is part of the barbecue to cylinder | all burner control knobs and the cylinder | ||
| position. | connection, may have activated. | valve OFF. Disconnect the regulator from the | ||
| Barbecue temperature only reaches |
| cylinder. Turn burner control knobs to HIGH. | ||
| 250˚ to 300˚ in the HIGH position. |
| Wait at least 1 minute. Turn burner control | ||
|
|
| knobs OFF. Reconnect the regulator to the | ||
|
|
| cylinder. Turn cylinder valve on slowly. Refer | ||
|
|
| to “Lighting Instructions”. |
|
|
|
|
|
|
|
|
| Burner does not light, or flame is low | Is LP fuel low or empty? | Refi ll LP cylinder. |
|
|
| in HIGH position. |
|
|
|
|
|
|
|
|
|
|
|
| Is fuel hose bent or kinked? | Straighten fuel hose. |
|
|
|
|
|
|
| |
|
| Does the Left burner light with a match? | If you can light the Left burner with a match, | ||
|
|
| then check the Crossover® ignition system. | ||
|
|
|
|
| |
| Experiencing | Are you preheating barbecue in the | All burners on high for 10 to 15 minutes for | ||
|
| prescribed manner? | preheating. |
|
|
|
|
|
|
| |
|
| Are the cooking grates and Flavorizer® | Clean thoroughly. (See Section “Cleaning”) | ||
|
| bars heavily coated with |
|
|
|
| CAUTION: Do not line the bottom | grease? |
|
|
|
|
|
|
|
| |
| tray with aluminum foil. | Is the bottom tray “dirty” and not allowing | Clean bottom tray |
|
|
|
| grease to fl ow into catch pan? |
|
|
|
|
|
|
|
| |
| Burner flame pattern is erratic. Flame | Are burners clean? | Clean burners. (See Section “Maintenance”.) | ||
| is low when burner is on HIGH. Flames |
|
|
|
|
| do not run the whole length of the |
|
|
|
|
| burner tube. |
|
|
|
|
|
|
|
|
| |
| Inside of lid appears to be “peeling.” | The lid is stainless steel, not paint. It | Clean thoroughly. (See Section “Cleaning”.) | ||
| (Resembles paint peeling.) | cannot “peel”. What you are seeing |
|
|
|
|
| is baked on grease that has turned to |
|
|
|
|
| carbon and is fl aking off. |
|
|
|
|
| THIS IS NOT A DEFECT. |
|
|
|
|
|
|
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.