Weber 1200 owner manual Add front panel, Add cooking box

Step 7

Add front panel

You will need: front panel and two plastic buttons.

Turn frame assembly right side up.

Align the panel with the holes in the frame and insert the plastic buttons through the front panel and frame. Figure 6.

Plastic buttons

View from rear

of barbecue

Step 8

Add cooking box

You will need: frame assembly, cooking box assembly, 1/4-20 x 2 inch bolt, nylon washer, 1/4-20 keps nut, pliers and a 7/16 inch wrench.

Set the cooking box in the frame so the burner tubes are under the frame brace. Figure 7.

Burner tubes

Frame brace

		Figure 7
	Slide the cooking box to the left within the frame. Put the
	washer on the bolt. Take the spacer bracket and hold it up
	to the frame making sure both tabs fit underneath the
	frame cross piece. Figure 8 (a). Insert the bolt through the
	center hole in the spacer bracket, frame and cooking box
Figure 6	with the head of the bolt outside the spacer bracket.
	Figure 8 (b). Add keps nut. Figure 8. Tighten by holding
	the bolt with pliers while you tighten the nut with a wrench.
		Frame
		cross piece
		(a)
		Spacer bracket
	(b)	Keps nut

Tab

Bolt

Nylon washer

Figure 8

12