Weber 2000 owner manual Check that all burner valves are off, Connect flexible hose to manifold

Page 15

Step 11

Check that all burner valves are off

You will need: one burner control knob.

(Valves are shipped in the OFF position, but you should check to be sure.) Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn they are off, proceed to the next step. Figure 12.

Figure 12

Step 12

Connect flexible hose to manifold

You will need: the 12 foot natural gas supply hose and a 3/4 inch wrench.

Thread fitting end of hose onto manifold. Figure 13 (a). Tighten with wrench.

(a)

Figure 13

15

Image 15

Contents Genesis 2000 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Storage For Installation in CanadaGas supply testing General InstructionsAssembly Check package contentsStep Left hand slide bar assembly Check contents of hardware packs Assemble frame Assemble wheelsContinue frame assembly Complete frame assemblyInsert casters Add cooking box Install igniter Install manifold bracketTest connections Install gas supplyGeneral Specifications for Piping Gas line pipingConnect flexible hose to manifold Check that all burner valves are offMWARNING Do not ignite burners while leak checking Check for gas leaksInstall the bottom tray Install Flavorizer Bars and Cooking GratesInstall tool holders, control panel and burner control knobs Install the lidInstall swing table Complete accessory installation To Extinguish LightingManual Lighting Periodic Cleaning CookingStorage and/or Nonuse Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceReplacing Main Burners General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Troubleshooting & Maintenance Page 13-14 10,14 MWARNING Parts ListFinal Word Thanks