Weber 2000 owner manual Manual Lighting

Page 22

Manual Lighting

mDANGER

Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

1)Open the lid. Figure 2.

2)Make sure all burner control knobs are turned OFF. (Push each burner control knob down and turn clockwise.)

3)Turn gas supply valve on.

4)Strike a match and put the flame into the matchlight hole in the front of the cooking box.

1

Manual Lighting

2

7

3

6

4

5

Figure 2

mWARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

5)Push Front burner control knob down and turn to START/ HI.

6)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box.

mWARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

7)After the FRONT burner is lit you can turn on the other burners.

Note - Always light the FRONT burner first. The other burners ignite from the FRONT burner.

To Extinguish

Turn gas supply OFF at the source, then push down and turn each burner control knob clockwise to OFF.

22

Image 22
Contents Genesis 2000 Series MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents General Instructions For Installation in CanadaGas supply testing StorageCheck package contents AssemblyStep Left hand slide bar assembly Check contents of hardware packs Assemble wheels Assemble frameComplete frame assembly Continue frame assemblyInsert casters Add cooking box Install manifold bracket Install igniterGas line piping Install gas supplyGeneral Specifications for Piping Test connectionsCheck that all burner valves are off Connect flexible hose to manifoldCheck for gas leaks MWARNING Do not ignite burners while leak checkingInstall Flavorizer Bars and Cooking Grates Install the bottom trayInstall the lid Install tool holders, control panel and burner control knobsInstall swing table Complete accessory installation Lighting To ExtinguishManual Lighting Cooking Periodic CleaningStorage and/or Nonuse Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMain Burner Flame Pattern General MaintenanceWeber Spider Stopper Guards Replacing Main BurnersTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Troubleshooting & Maintenance Page 13-14 10,14 Parts List MWARNINGFinal Word Thanks