Step 2
Remove protective packaging
Protective cardboard inserts must be removed from the bowl before assembly. Figure 2. DO NOT FORCEFULLY REMOVE THE INSERTS.
a)Remove cardboard insert from ash catcher ring. Be careful when removing the cardboard not to bend the ash catcher ring.
b)Tear cardboard along the perforations at leg couplings and pull downward.
c)Peel off the protective plastic covering from the nameplate on the ash catcher ring.
(a)
(c)
(b) 
(b)
Step 3
Assemble the frame
You will need: top frame assembly, wheel frame assembly and caster frame assembly.
Note - Work on soft surface (grass, or carton inserts) to protect the finish during frame assembly.
Set the top frame on the ground so the leg tabs point up. Fit the wheel frame assembly onto the leg tabs at the open end of the top frame. Figure 3.
Fit the caster frame assembly onto the leg tabs at the other end of the top frame. Figure 3.
The tabs must be on the inside of the frame tubes when the joints are closed. Figure 3 (a).
Tab on the inside of frame tube
Figure 2
(a)
Figure 3
10