Weber 3994601 owner manual Add bowl panel, tool holders and CharBin Storage Container

Step 12

Add bowl panel, tool holders and CharBin Storage Container

You will need: bowl panel, three tool holders and CharBin Storage Container.

Remove protective plastic covering from bowl panel.

Slide the ends of bowl panel under bowl mounting brackets so the ends rest on tabs inside frame. Set the panel in place on top of the frame brace. Figure 13.

Hook the tool holders over the frame rail. There is a cut-out on the right side of the front panel to accommodate the tool holders. Figure 13.

(a)

Tab

Bowl panel

Tool holders

Figure 13

Note: Before sliding the CharBin into place check that the Cooking grate holder is sitting loosely on the frame brace and is conforming to the frame brace. Figure 14 a. If it is tight or stuck over the edge of the frame brace, Figure 14 b, reposition as in Figure 14 a.

If the Cooking grate holder is not correctly positioned, it could allow the CharBin to slide through the frame.

Slide CharBin down into the top frame with the deep end toward the rear. Figure 14.

Inside of	(a)
Frame Brace
Cooking grate
holder

(b)

CharBin

Figure 14

16