Weber PERFORMER TOUCH-N-GO IGNITION, 3994601 owner manual Assemble wheels

The following items will be found in the hardware pack.

Sixteen nylon washers (actual size)

Four aluminum washers (actual size)

Eight 1/4-20 x 1 3/4 inch bolts (actual size)

Four 1/4-20 acorn nuts (actual size)

Four 1/4-20 x 1/2 inch bolts (actual size)

Three tool holders

Three hubcaps

Step 1

Assemble wheels

You will need: axle, two wheel hubcaps, two wheels, wheel frame, hammer and a block of wood.

Place one end of the axle on the block of wood (or other protected surface). Tap on one hubcap.

Put one wheel on the axle, WEBER side toward the hubcap. Slide the axle through the frame. Add the other wheel, WEBER side out. Tap on the hubcap. Figure 1.

EB	R	W
W			E
		R	B

Figure 1

9