Weber PERFORMER TOUCH-N-GO IGNITION, 3994601 Periodic Cleaning, Storage, Refilling the LP tank

Page 21

Periodic Cleaning

To remove ashes from the bowl, move control rod side to side so damper blades sweep ashes through the bowl vents and into the ash catcher. Figure 7.

Control rod

Figure 7

CAUTION: Be sure that burner is OFF and barbecue is cool before cleaning.

Do not enlarge burner slots when cleaning.

To clean burner: Brush the outside of the burner tube and the burner slot section with a brass wire brush. Figure 8.

Burner slot

Figure 8

CAUTION: Do not enlarge the burner slots or the gas orifice when cleaning.

TO CLEAN KETTLE:

While lid is warm, wipe the inside with a paper towel to prevent grease buildup.

For outer surfaces use a warm soapy water solution and rinse well with clear water.

For a more thorough cleaning (to be done at least once a year):

1.Remove ashes after coals are fully extinguished.

2.Remove the grates and Char-Baskets.

3.Clean the porcelain finish with with a spray-on type oven cleaner. Spray surfaces heavily with the oven cleaner and leave on long enough to soften accumulated grease.

4.Wipe out with paper towels. Wash with a mild detergent and water. Rinse well with clear water and wipe dry.

Storage

When the Performer Grill is stored indoors, the gas supply MUST BE DISCONNECTED and the LP tank stored outdoors in a well-ventilated space.

LP tanks must be stored outdoors in a well- ventilated area out of the reach of children. Disconnected LP tanks must have threaded valve plugs tightly installed and must not be stored in a building, garage or any other enclosed area.

After a period of storage and/or nonuse, the barbecue should be checked for gas leaks and any obstructions in the burner tube before using. (See section “Maintenance.”)

Check that the areas around the tank, hose and burner assembly are free from debris that might obstruct the flow of gas or air.

Refilling the LP tank

Removal of the LP tank

1)Close tank valve (turn clockwise).

2)Slide the collar back on the quick disconnect to disengage the fitting. Figure 9.

Tank valve

Figure 9

3) Lift tank off.

To refill take LP tank and tank filler adapter to a "Gas Propane" dealer.

WARNING: We recommend that your LP tank be filled at an authorized LP gas dealer, by a qualified attendant, who fills the tank by weight. IMPROPER FILLING IS DANGEROUS.

CAUTION: If you exchange your LP tank, make sure you get a similar tank in return. Your LP tank is equipped with a quick-disconnect valve. Other LP tanks are not compatible with your barbecue connection.

21

Image 21
Contents Performer Page Customer Service Center South Hicks Road Palatine, IL 800 WarrantyPatents and Trademarks Contents Storage General InstructionsCheck package contents Assembly InstructionsFollowing items will be found in the bottom carton Following items will be found in the hardware pack Assemble wheelsAssemble the frame Remove protective packagingComplete frame assembly Continue frame assemblyUncover CharBin lid Install bowl assemblyRemove protective plastic covering from CharBin lid. Figure Four bolts are correctly in placeInstall igniter Fill LP tankImproper Filling is Dangerous Install and connect filled LP tank BARBECUE. Contact your dealer Check for gas leaksRemove protective plastic covering from bowl panel Add bowl panel, tool holders and CharBin Storage ContainerAdd grates, Char-Basket Fuel Holders and lid Install ash catcher, control panel & bottom rackLighting Operating InstructionsInsect Alert Manual LightingCooking Methods Direct MethodIndirect Method To Clean Kettle Periodic CleaningStorage Refilling the LP tankConnecting the LP tank Safe handling tips for LP Gas Products Co., Customer Service CenterLiquid Propane LP Tanks LP tank requirementsTroubleshooting & Maintenance TroubleshootingThis is not a Defect Inspecting and Cleaning the Burner MaintenancePeriodic Quick Cleaning Ignition SystemBurner Flame Pattern Page 12-13 14-16 18, 15-16 19-20, 15 29,20 41-42 47-48 49-52 Parts List Final Word Thanks