Connecting the LP tank
WARNING: Make sure LP tank valve is closed. Close by turning clockwise.
You will need: filled LP tank, a soap and water solution and a rag or brush to apply it.
Lift LP tank onto tank holder.
Slide back the collar of the quick disconnect on the tank valve. Figure 10 (a). Push the male fitting of the regulator into the quick disconnect, and maintain pressure. Slide the collar closed. Figure 10 (b). If it does not engage or lock, repeat procedure. Gas will not flow unless the quick disconnect is properly engaged.
Check the following connections, as shown in figure 11:
a)Test valve to regulator connection.
b)Quick disconnect fitting to LP tank connection.
If bubbles occur, or if a bubble enlarges, the connection is leaking, turn OFF the gas at LP tank.
If the leak is at connection a) DO NOT OPERATE THE
BARBECUE. Contact your dealer.
(a) (b)
(a)
Male fitting
Regulator
(b)
Quick disconnect retracted
Collar |
Quick disconnect engaged
Figure 10
Mix soap and water.
Open the tank valve.
DANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or death and damage to property.
WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.
Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.
To perform leak checks: Turn test valve to the CLOSED position. Figure 11. Turn tank valve ON (counterclockwise). Check for leaks by wetting the connections with the soap and water solution and watching for bubbles.
Test valve in CLOSED position Test valve in OPEN position
Figure 11
If the leak is at connection b), disconnect and reconnect the quick disconnect fitting. Turn the gas back on and recheck with the soap and water solution.
WARNING: If leak persists after tightening the connection, turn OFF the gas at LP tank. DO NOT OPERATE THE BARBECUE. Contact your dealer.
After completing the leak checks:
a)Turn the LP tank valve OFF (clockwise) and rinse connections with water.
b)Turn the test valve to the OPEN position (parallel to the hose). Figure 11.
LP Tank
The LP tank manufacturer is responsible for the materials, workmanship and performance of the tank. If the tank has a defect, malfunctions, or you have a question regarding the tank, call the tank manufacturer's customer service center. The phone number is on the warning decal which is permanently attached to the tank. If the tank manufacturer has not resolved the issue to your satisfaction, then call
22