Brinkmann Pro Series 2500 owner manual Lighting Instructions, Lighting the Main Burners

Page 10

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the cylinder valve are turned to the OFF position.

3.Turn on the fuel supply by rotating the cylinder valve knob counterclockwise to full open.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1.Open lid before lighting burner.

2.Make sure all control knobs are in the OFF position.

3.Select the burner to be lit. Push and turn the control knob of that burner to the HIGH position.

4.Press the electronic igniter and hold for 3-5 seconds until burner ignites.

5.If burner does NOT ignite immediately, turn the burner control knob to OFF, wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 5 until burner ignites.

6.If burner does not ignite using the push button igniter wait 5 minutes, see "Match Lighting the Main Burners" section.

7.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the HIGH position.

MATCH LIGHTING THE MAIN BURNERS:

1.Open lid before lighting.

2.Turn the burner control knobs to OFF.

3.Strike and place a long wooden match through lighting hole in the right hand side of the grill to approximately 1/2" (2 to 3 cm) from the burner.

4.Turn on the FAR RIGHT burner control knob to the HIGH position. The burner should light within 5 seconds.

GRILL LIGHTING INSTRUCTIONS:

 

 

 

 

1.

Read and follow all warnings and instructions

5.

Press the electronic igniter and hold for 3-5

7.

Repeat Steps 4-6 for lighting each burner. Always

 

in owner’s manual before lighting.

 

seconds to light burner.

 

use electronic igniter for lighting each burner.

2.

Open lid before lighting burner.

6.

If burner does NOT ignite immediately, turn control

8.

Refer to owner’s manual for match lighting procedure.

3.

Make sure all control knobs are in the OFF position.

 

knob to OFF, wait 5 minutes to allow gas to

9.

For assistance, call 1-800-527-0717.

4.

Select the burner to be lit. Push and turn the control

 

dissipate and repeat lighting procedure.

10. To turn off, turn control knobs clockwise until it locks

 

knob of that burner to HIGH.

 

 

 

in OFF position.

FOR OUTDOOR USE ONLY

Lighting Hole

5.If the burner does not light, turn the control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 5 until the burner ignites.

6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the HIGH position.

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual.

9

Image 10
Contents Gas Stainless Steel Outdoor Grill Important Safety For Your SafetyPage Installation Information Cylinder SpecificationsPage Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder When to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Match Lighting the Side Burner Lighting the Side BurnerTurning OFF the Grill Preheating the Grill Operating the GrillBreaking in Your Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerSmoker BOX Transporting and StorageBefore Storing Your Grill Hardware Cleaning and MaintenanceBurner ASSEMBLY/MAINTENANCE CastingsTrouble Shooting Problem Possible Causes Burner will not lightGrilling to Proper Temperature CleanlinessHelpful Hints Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts Card Contents Step Step Attach back cart panel by using four M6 X 50mm bolts Install door bracket using four Spring Pin Lower Pivot Screw Holes Procedures. See Grill Bottom Grease Tray Place warming rack in slots above cast iron cooking grills Pro Series 2500 Assembled Accessories Gallon PAN & Basket SET Warranty